Question about Philips Philishave HQ7830 Electric Shaver

2 Answers

How do I replace the battery

How do I replace the recharegeable battery?

Battery is only holing its charge for 2 days

Thanks!

Posted by on

  • Anonymous Mar 20, 2014

    the battery (6 years old) charges lasted 1-2 days. on my last attempt to charge, smoke came out. the capacitor next to the battery (-) terminal found burned (2.2uF 384v). i need info for the battery and capacitor. thank you

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

Take it apart and go to batteries plus and get a new pack made. or take it to them. it may cost more to do that then to buy a new shaver. that is what the manufactureres are counting on.

Posted on Jul 18, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Philips Master
  • 1,598 Answers

The batteries can be replaced. Some soldering is required. If you are capable, you can do it yourself or you can have it professionally done. shaveroutlet.com offers the batteries or repair service. See links below

http://shaveroutlet.com/shaver-battery-pack-for-most-norelco-more-p-278.html

http://shaveroutlet.com/professional-battery-replacement-for-most-models-p-374.html

If you decide to have it professionally done, you can simply purchase the repair service from the website and follow the instructions for sending it in to the company.

If you do it yourself, you will need toremove the two screws on the back of the shaver to remove the back cover. You will the see the batteries andwhere they are connected to the circuit board.
You may find it easy to use a modified installation technique. This is to break the tabs off of the old batteries rather that removing them from the circuit boardhow do I replace the battery - 2_bing.gif. You can use a small flat screwdriver or similar object to do this. This allows the old batteries to be removed but leaves their tabs attached to the circuit board. You can then solder the tabs from the new batteries to the old existing tabs

Posted on Jan 24, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bought a new battery pack (jensen brand) for panasonic 5.8GHz gigarange supreme KX-TG6500 2Line cordless phone and it wont charge.


check that you got the right make of battery for the charger
some phones use a nicad battery and others use a lit ion battery
2 different recharegable batteries -- 2 different chargers required

Nov 29, 2016 | Panasonic Lands Phones

1 Answer

How do i charge the battery


are you using rechargeable batteries? if not do not try to recharge them.if you are then they should have their own charging unit.recharegable batteries can save you a lot of money and can be purchased just about anywhere.

hope this helps.

Jan 09, 2011 | Vtech Kidizoom Digital Camera

1 Answer

Hello, After fully charging my mother's Jazzy power chair overnight, the rear battery indicator/pointer shows zero meaning it's fully charged. I leave it unplugged all day and then by 5pm when I check...


Sorry but it sounds like weak batteries. I would replace both batteries and after installation fully charge before use. Then ask Mom to use the chair more each day so you can charge them overnight each day for the next 20 days. It will break in the batteries and get them operating at 100%. If you can get her to use it more and charge it overnite and always put it up at full charge the batteries should last 2-3 years Hope this helps

Dec 16, 2010 | Jet 7 Portable Power Chair

1 Answer

Charging continues to flash even after 3 hours of charging Toshiba camileo h30? Booklet said it should stop flashing when charged, but hasn't. Thanks in advance Paul


have you checked that the charger is charging the camera battery up?????
it could also be a dud camera battery,,if one cell is duff the hole battery wont charge up to its full volts so the charger works its **** off trying to charge up a dud battery till one day the charger just burns out as well?

Nov 27, 2010 | Toshiba Camileo H30 Hard Drive Camcorder

1 Answer

My kiddy zoom camera will not turn on. ive changed the batteries and tried to reset with a toothpick but still nothing, its totally dead. any suggestions please?


It is possible that there is a fault, or that the battery connections in the camera are dirty or corroded, but digital cameras are famously demanding on batteries. You must use good alkaline batteries or better, a set of high capacity NiMH recharegables. Zinc or "long life" batteries just aren't up to the task.

New rechargeable batteries are supplied only partially charged. You need to charge them fully before use.

It is possible to insert one or both of the batteries the wrong way around. There should be a little +/- graphic or picture of a battery on the compartment to show you which way each battery goes.

Oct 29, 2010 | Vtech Kidizoom Digital Camera

1 Answer

My vivicam 5050 camera says the battery's are dead even when there new battery's. is there anyway to stop this? the battery's work perfectly outside the camera i don't know what the problem could be....


It is possible that there is a fault, or that the battery connections in the camera are dirty or corroded, but digital cameras are famously demanding on batteries. You must use good alkaline batteries or better, a set of high capacity NiMH recharegables. Zinc or "long life" batteries just aren't up to the task.

New rechargeable batteries are supplied only partially charged. You need to charge them fully before use.

Oct 29, 2010 | Vivitar ViviCam 5050 Digital Camera

1 Answer

1.why do my batteries last such a short time. They last around a day. . 2.When i put my sd card in these funny pictures come up on my images how do i put my original photos with that. Many thankx


Digital cameras are famously demanding on batteries. You must use good alkaline batteries or better, a set of high capacity NiMH recharegables. Zinc or "long life" batteries just aren't up to the task.

New rechargeable batteries are supplied only partially charged. You need to charge them fully before use.

I don't understand your description of the problem with the SD card. When you take pictures they will automatically be stored on the memory card. Are you saying there are other pictures there already?

Oct 29, 2010 | Vivitar ViviCam X327 Digital Camera

1 Answer

My C-3000 indicates that the batteries are dead even if I put new batteries in the camera.


It is possible that there is a fault, or that the battery connections in the camera are dirty or corroded, but digital cameras are famously demanding on batteries. You must use good alkaline batteries or better, a set of high capacity NiMH recharegables. Zinc or "long life" batteries just aren't up to the task.

New rechargeable batteries are supplied only partially charged. You need to charge them fully before use.

Oct 29, 2010 | Olympus C-3000 Zoom Digital Camera

1 Answer

Camera saying batteries exhausted,when new batteries in


You must use good alkaline batteries or better, a set of high capacity NiMH recharegables. Zinc batteries just aren't up to the task.

New rechargeable batteries are supplied only partially charged. You need to charge them fully before use.

Oct 28, 2010 | Nikon COOLPIX L20 Digital Camera

1 Answer

Hi i have a CANON A1000 IS and I just got it a week ago and the batteries lasted me 2 days. I tried charging my camera but when i went to turn my camera back on it said low batteries then immedietly after...


Hello,
Are you installing Nmh (Nickle- Metal Hydride) rechargable batteries?
If not then your camera probably will not recharege them.
Also trying to recharge non rechargable batteries can cause damage to the battery, and possibly your camera.
Hope this is helpful.
Tom

Jan 05, 2009 | Canon PowerShot S100 Digital Camera

Not finding what you are looking for?
Philips Philishave HQ7830 Electric Shaver Logo

547 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips Health & Beauty Experts

shaveroutlet.com
shaveroutlet.com

Level 3 Expert

1598 Answers

kakima

Level 3 Expert

102366 Answers

xxxxxx xxx

Level 3 Expert

4836 Answers

Are you a Philips Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...