I have ix800 overload light is on wont produce power.what could be the problem?

need a meter to diagnose and test circuit and wiring ---check breakers also

is anything plugged into the gen when you reset it?
If so unplug everything and try again.
If not, it is an internal problem with the inverter.

The transformer is likely sized for one string and is being overloaded by adding the additional lights.

LEDs require a transformer that converts household AC(alternating current) to DC(direct current). The minimum amperage produced by the transformer, must exceed the minimum amperage required by all of the LEDs or none of them will emit light.

check the circuit breaker on the unit for overload
the unit only produces effective 6000 watts continuous and if everything is used , that will be exceeded and the overload will trip

Yes, buy yourself a heatgun and replace that capacitor.

The toggle switch automatically resets all faults when it is turned to the off position. I would turn the toggle switch off, turn off the breaker on the generator and then turn off all the loads in the house except a few lights. Turn the generator breaker back on, then turn the toggle switch back to automatic. If it starts and stays running, you were overloading the generator. Turn on other loads slowly and keep track of what is on so you don't overload it again. If it still does not stay on, you may have a problem with the panel. Let me know what happens.

return to Fluke for service

Generally speaking, an amp attempts to protect itself from heat, shorts, overloads and operator exuberance by refusing to turn on or stay on; or it may turn on but produce no audio to the speakers.

Overloads can be from excessive periods of high output or marginally low impedance loading by the speakers; and shorts would be wiring issues or a speaker blowing up.

You should be able to feel if it's hot. WHY is it overheating? Make sure it has sufficient ventilation on all sides and that vent holes are not blocked by dust balls. Ensure the fan (if equipped) is running as designed (some only operate on demand). Clean dust and debris from it.

If the amp comes back on after cooling, you're lucky. They only have so many self-protection cycles in their lives so continuously resetting or cycling their power without addressing the cause can do more harm than good.

If it protects immediately on a cool power up you should disconnect the speaker connections and try it 'nekkid'. If it comes up then diagnose which lead(s) are shorted. If it does not come up the problem is internal and should be left to an experienced and competent hands-on tech.

how can I reset fault code 427 CAN degrade qsx15