I have a uniplay pink car'beach cruiser' the propeller which turn the main tyre is not working, does anyone know where i can buy one.Thanks

There should be 6 relays in the fuse box. Using your manual, find the turn signal relay and replace it.

Fit standard profile wheels and tyres.

Have you tested for a ground control signal at the injector connection ?

Have you had work done in this area recently? If not then its possible it doesn't connect to anything on your model.

if you mean erase the codes, you will need obd2 scanner for 1996 to now- got one from ebay for under 20 bucks- works great

Hi,
This is located at the bottom of the battery tray and the wiring colors are: 1. Pink/Yellow trace 2. Brown/Yellow trace.
Let me know if you need more information.
Thanks
Jason

I don't know if your serpentine belt layout is the same as mine. I have a 2005 2.4TD. I worked out that the tensioner is spring loaded and needed to be turned using a very long spanner (can't remember the size as I used an adjustable spanner with a piece of pipe to get the length - 19mm sounds right). Get the belt wrapped round the other pulleys and then turn the tensioner pulley nut a quarter turn or so then the belt should slip onto the last idler pulley. Make sure all pulleys have any rubber residues and oil/muck cleaned off. Very tight for space so you'll probable end up using yours fingernails and a rag with some petrol or WD40 on it. Re-fitting the engine pan was the worst bit. **** design for the fittings. Replaced these with self-tapper screws to make sure it stays on as the original clips don't like being taken off and put on too many times. Thanks Chrysler. By the way I'm never buying a Chrysler again. Had to replace both wishbones after 3 years - a common problem I'm told - and also this is the 4th serpentine belt in 8 months and its going to be an expensive process of deduction to find out what the problem is. Recirculate button for the aircon has also decided to stop working. Great news given that its minus 3 outside and the car takes 20 minutes to warm up the interior as its sucking in cold external air. I've also got a 1996 Toyota Picnic 2.0 auto with double the mileage that I've owned for 5 years. All I've ever had to do with that is replace a rear lightbulb and I know the previous owner who never had a fault with it. 14 years old and only needed one bulb changed in all that time! Still on the second set of tyres too. Best car I've ever had. The Cruiser is turning out to be as expensive to maintain as my old Citroen XM, and they are famous for maintenance problems. Lovely car though. Hope this helps and puts people off buying Chrysler ****...

prado is a kind of land cruiser.

The original tire equipment size is 275/70-16 for those vehicles.
If you are currently using 265/70-16 and plans to upgrade to 285... Make sure you verify if your Cooper tires size reflects 285/65-16.
Because, this is the only way you can keep your current settings unchanged with respect to the wheel/tire well size.

Effects (according to Miata.net Tire Size Calculator):
*So, the sidewall remains 7.3 in, the radius (15.3 in) will stay the same, the diameter (30.6 in) will not change, and the number of tire revolutions/mile ( approximately 659.0 revs/mile) remains the same.
Expect, however, the circumference to change only changes from 96.2 in to 96.1in (not a big deal).

Thomas Heime is wrong, wrong, wrong! That is the max. pressure that the tyre can handle! the proper tyre pressure is written below the latch on the passenger side door. Open the passenger door, look at the label below the latch and there it is.