Question about Heating & Cooling

1 Answer

Re: Kenmore Plasmaire air conditioner; suddenly stopped working during night. Motor will initially turn on but no air coming through, then will stop

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 30 Answers

Most likely you have a bad fan,did you have a storm or lighting strike or power drop / outage .
These type of things can cause trouble with a weak electrical part - not know the age of the Unit - you claim it happen in the middle of the night - if the fan Humms and cut outit could be a cap. that helps you fan start - but the fan is damaged if it tryed to start time and time again . Call service if the unit is worth it .

Posted on Jul 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air cond. suddenly stopped working on honda pilot 2007 model


Check the blower motor and blower resistor.

Jul 07, 2014 | 2007 Honda Pilot

1 Answer

My 2002 trane XE 1200 gas &electric unit stopped blowing air


it may be the blower motor not working inside the house check the cap for the motor & the power to the motor

Apr 28, 2014 | Heating & Cooling

1 Answer

Repaced fan motor, capacitor, contactor still fan not working.


press the contactor in using a wooden pencil does it come on? if so then you are not getting a control signal from the tstat or a low pressure (low freon switch) is open stopping the contactor from pulling in

May 21, 2013 | Goodman CKL49AR49 Air Conditioner

1 Answer

Kenmore Plasmaire air conditioner causes braker to throw each time it plugs in. did this suddenly after working well for months.


there has to be to much on that curcuit to run a/c. the best thing to do is have it on its own curcuit or on a curcuit where the amperage load is lighter. good-day !! this may have happened because when new, it did not draw to many amps.but with continuous use it wears on the motor etc. and is taking more amperage to run it. when I got my a/c about 4 years ago, I put it on its own curcuit. no problems yet! good-day !

Jul 16, 2011 | Kenmore 71055 Air Conditioner

1 Answer

This is a sears kenmore plasmaire. just stopped running. electric sockets are fine. could this be the switch or the cord?


If it is a 240volt air cond. be sure to reset both circuit breakers. They will be side by side and may be joined together

If it is a j120 volt unit, it will be on a single breaker, make sure you don't have a lot of other lights, etc. on the same circuit or the breaker will get hot and trip continually.

Only other thing I can think of for you is make sure the unit thermostat is not turned up to a temp higher than the inside temp. Hope any or all of this helps you. Mark

Apr 18, 2011 | Kenmore Heating & Cooling

1 Answer

Noise, now starts for a few seconds and dies


the blower motor has shorted out and its taking the motherboard with it. I hate to say this but I think you already know its time for a new unit
the average life span is about 3 years on this model so its had a good run I hope this helps

Jul 20, 2009 | Kenmore 76100 Wall/Window Air Conditioner

1 Answer

My maytag m7y12f2a stopped working is their any reset buttons


All devices that have circuit boards or digital displays need a surge protector or turn off during storms. If none of the functions or dispays don't come up, there may be an inline fuse on the panel. More than likely the board or transformer is fried. For that you need a Tech.

Jul 09, 2009 | Heating & Cooling

1 Answer

Fan not working


the humm could be the contactor check the breaker for the out side unit or see that you have power at the unit dan

Jul 17, 2008 | Carrier 38CKC036 Air Conditioner

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

786 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

Paul Carew

Level 3 Expert

3083 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Tim Whalen

Level 3 Expert

3074 Answers

Are you a Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...