My JBL Go switchs off automatically - JBL Audio Players & Recorders

Hello, I send you the user manual so that you follow the steps indicated there, about the connections, which could be generating the inconvenience
I hope you manage to make your JBL work correctly
Greetings Franco Dosil

Hola, te envio el manual de usuario para que sigas los pasos ahi indicados, sobre las conexiones, las que podrian estar generando el inconveniente
Espero que logres hacer funcionar correctamente tu JBL
Saludos Franco Dosil
https://www.manualslib.com/manual/284439/Jbl-Escxcite-System.html

In the USA, JBL G730 cabinets come with 1/4" connectors instead of Speakons normally. Either way, the switch on the rear of the cabinet on the crossover is a pad for the horn which lowers it's output. Normal is the middle position, upper the horn is louder, lower the horn is softer

what operating system is laptop ?
is it windows vista ?
https://support.microsoft.com/en-us/help/933144/the-audio-output-is-not-automatically-routed-to-a-bluetooth-audio-devi

Yes, follow this sequence:
1. Turn the device on
2. Press the call (phone icon) and the volume up (+) button at the same time and keep them pressed. After a few seconds the speaker will shut down.
3. Release the buttons.
4. Turn the speaker back on. It will automatically enter into search mode... And there you are, memory wiped up.
Good luck.

Fuses blow when something is shorted. In this case it will be a semi-conductor of some kind. If the device uses IC for the main amplification then you are right to be worried!

The 158 amp is totally unsuitable for the JBL.
This is the specification of the JBL:

• Recommended Amplifier Power 10 Watt
  
• they are also 4 Ohm speakers.
• 158 is: Output Impedance / Channel
  8 Ohm.

Protection circuits are on most activated after about 3 seconds.

If there are no faults detected it will power up normally.


If you need to troubleshoot and feel you can ,

post so I can help you further.

Everyone keeps talking about a reset small hole around eject button/ power switch. I have the JBL 6 disc changer. Where is this reset hole on that system? 2002 Camry.

Look here:
http://manuals.harman.com/JBL/HOM/Service%20Manual/PB10%20sm.pdf
http://manuals.harman.com/JBL/HOM/Service%20Manual/PB12%20sm.pdf
This is how I fixed my since module is no around any more.
http://s807.photobucket.com/albums/yy352/budm/JBL%20PB-12%20mod/

these a internal power control board defective, send to repair

Just plug it in to an outlet. The lights on the front should be red (or standby mode). When it gets a good sound signal, it turns green (that's when it's on). It does not have a power switch.