No color vertical lines ghosting

need for repair. faulty lcd screen

This seems to be a problem with some older panels. If you are prepared to tackle the problem yourself then try the following.
WARNING there are some very high voltages within the TV which can be LETHAL so the greatest of care should be taken.

With the back of the TV removed, use a hair dryer and apply warm air to all the ribbon cables in turn until you find the one which causes the fault to disappear. Now turn your attention to the faulty ribbon and remake the connections as necessary.

Its not a "capacitor" problem. Does the picture look like its in 3D, ie colored ghosts around images? If so, its a convergence failure. You'll need to replace the convergence output ICs and a couple of fuse. Also, there is a jumper connection that needs to be re-soldered or it will happen again. You should probably contact a Toshiba authorized service center to resolve this. Expect to spend $400-500

michtech

put a towel across the top of the tv so it can heat up faster and you will get your picture. be carefull!!

it could be a ghost but most likely a bad solder connection , crystal(controls the eprom)(menu chip) , or the eprom chip itself will need to be replaced

I have found that vertical lines that suddenly appear from projectors are due to poorly connected cables. Sut off your projector and wait for the fan to go off. Then unplug the connectors from the computer to the projector and secure them again, making sure to go all the way. Hope this helps.

Philips 50 inch plasma tv no video but has sound

sir do a power reseet ,turn off the tv then unplug it from the electrical source then wait for 1 minute then plug it in and turn it on if it doesn't work call sony customer serveice at 1800 222 7669

there is no convergence adjust in a 32" tv. Convergence is done when there is more than 1 picture tube, ie; 50" projection sets have 3 tubes so convergence can go out. post the model number of your set and we can help more, BMW Rider

JAIL BARS IN PICTURE, CHECK C2B1 100 UFD 16V OFF PIN 2 IC202 ON THE MAIN PCB. If this does not help let me know.