Linksys orint server

This is going to be the password that you setup your router with. If you cant remember the password you can reset your router and put in a new password.

you need to open a browser and enter the numbers 192.168.0.1 in the address bar. it will ask for a user name and password. the default user name and password is "admin". if you have entered a different password while setting up the wireless connectivity, please use that password. once you entered the credentials, you can disable the DHCP server in the setup page of the linksys router. i have attached a screen shot for your reference. if you have any difficulties in doing this process, please reply to this message. hope it helps you.

Start Internet Explorer.
Login to the web-server "inside" the router.
Run the "Wireless Network Setup Wizard",
to enable 'WPA' and to set a password/passphrase.

Have you already setup the router? If so then you need to get the (WEP) password you had created. If not you might want to open up a browser window and in the url address window type in the following:

192.168.1.1

A username and password prompt will open and this is where you would place the password "admin" into the password area. Leave the username blank.

You then need to go into the settings and set you Security for the wireless portion. That key would be the one you will use when the psp ask for the password.

Hope that helps you out!

have yoiu loaded the linksys software on eachmachine?/
Seen like that us the missing link.

linksys always has a default password.
admin
admin
If you changed it you can reset it by holding down the reset in the back and unpluging it.

use "admin"

use-ly it is user name is (admin) password is (admin)

You?ll need to setup Port Forwarding to set up a PPtP tunnel behind a Linksys router. Please follow these instructions to setup the router to forwarding incoming PPtP traffic to your PPtP server: Getting Started 1. You must set a static IP address on the server. If you're unsure of how to do this please go to our Answer ID 534 for information on setting a static IP address in Windows. 2. Once the static IP address has been assigned please go to your desktop and double click on Internet Explorer (Located on the Start Menu in Windows XP) 3. Once "Internet Explorer" opens, please type http://192.168.1.1into the "Address Bar" and click GO 4. The "Enter Network Password" window will appear. Skip user name and type admin (admin is the default password) as the password, and click OK. 5. This will bring up the routers "Setup" section. Look under "Domain Name" and check what version of the firmware you're using. 6. You will need to click on the Advanced tab to the very right. Once the "Advanced" tab comes up please go to the Forwarding tab. Firmware prior to 1.32 This will not work with firmware prior to 1.32 Firmware between 1.32 and 1.36 Service Port Range 47 ~ 47 1723 ~ 1723 IP Address 192.168.1.3 192.168.1.3 Firmware after 1.36 up to 1.40m Service Port Range 47 ~ 47 1723 ~ 1723 Protocol Both Both IP Address 192.168.1.3 192.168.1.3 Firmware after 1.40m Customized Application VPN VPN Service Port Range 47 ~ 47 1723 ~ 1723 Protocol Both Both IP Address 192.168.1.3 192.168.1.3 Finishing up Click Apply, then Continue. Restart your computer