The catch on my miele revolution has come off completely of the accessory compartment; and I can not put back on; and don't know where to put back on! Bacically I am left with a black bit of plastic with a 2 hooks and a wire going across, and can't work out where this goes and how? Please can you help? Many Thanks Sally
Comments:
Jul 18, 2009
- Thank you, I think you are right. At least the actual vacuum cleaner still works. I will try a repair centre, thanks
Best Wishes Sally
Not sure about this, but have had a look at my own Miele which is similar. I suspect that, although it may not be visible, something must have broken to allow that catch to come off. Sorry, but you probably need a professional repairer to actually take a look at it.
got a roomba 440 for christmas i put in middle of floor and strt and it goes for like 5 min then...
(More)
got a roomba 440 for christmas i put in middle of floor and strt and it goes for like 5 min then quits and i have to hit the clean button again how do u just keep it going tell room is clean
my electrolux epic dors not stay on .When I push the knob it tuens on and turns off. 2 lights turn...
(More)
my electrolux epic dors not stay on .When I push the knob it tuens on and turns off. 2 lights turn on one shows plug and another one shows a full bag .I did put a new bag in it .
My wife has a Miele S548 Vacuum. Now when she pulls out the retractable power chord past a certain...
(More)
My wife has a Miele S548 Vacuum. Now when she pulls out the retractable power chord past a certain point, the vacuum shuts off and the built-in LED display says "700". Can you halp? Alan Metzger Glendale, Arizona USA
I have an S548 Aluminum canister vac that's about 6 years old. Tonight while I was vacuuming,...
(More)
I have an S548 Aluminum canister vac that's about 6 years old. Tonight while I was vacuuming, the LED on top of the powerhead that is normally green turned red and the brush stopped spinning.
I took the brush cover off the bottom, took off the top cover, took off the inner cover. The wiring and connections all seemed to be intact. I took the back cover off the neck of the powerhead (where it connects to the wand) and the two yellow wires in there looked good too.
I suspect the powerhead may need a new motor. Can someone let me know what the red light might mean.
Thank you in advance.