Question about Apple iPhone Smartphone
Sir if your are using a 3G iphone with AT&T as a carrier than please contact them for support
If your iphone is jailbreaked ie it is unlocked and you use it with some other carrier or in another country then update your iphone to firmware 3.0 using this step by step detailed guide
for iphone 2g using windows
for iphone 3g using windows
for iphone 2g using mac
for iphone 3g using mac
for further information about jailbreaking please contact me
NOTE I DONT RECOMEND YOU TO JAILBREAK IT... its illegal
Thanx and i hope this helps
PLease rate this solution THanx
Posted on Jul 17, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Jun 10, 2017 | 2006 Hummer H3
Feb 11, 2017 | Buick Cars & Trucks
Nov 28, 2016 | Cars & Trucks
Oct 17, 2016 | 2009 Chevrolet Chevrolet HHR LS
May 22, 2016 | 2007 Chevrolet Avalanche LTZ
The Turn Signal Indicator
The Sidemarker Lamp
The Sideview Mirror (Pontiac Thunder only)
The turn signal switch also sends a separate on-off signal to the Daytime Running Lamps (DRL) control module, which relays the signal to the appropriate front turn signal. The front turn signals are grounded at G101 and G102. The rear turn signals are grounded at G401. The sidemarker lamps are grounded through the corresponding front parklamp.
The sideview mirror turn signals are a bank of LEDs placed behind the mirror glass.
The hazard lamps operate on battery voltage. The HAZARD fuse supplies battery voltage to the turn signal switch. When the hazard switch is pressed, the turn signal switch sends battery voltage to the hazard lamp/turn signal flasher, which sends an on-off signal to the turn signal switch. The turn signal switch send the on-off signal to all the turn signal lamps, causing all the lamps to flash including both IPC turn signal indicators. The hazard lamp/turn signal flasher is grounded at G200.
When the parklamps are ON, the sidemarker lamps receive voltage from the park lamp supply voltage circuit and illuminate. The sidemarker lamp is grounded through the corresponding rear turn signal. When the turn signal switch is place in the left or right hand position, the rear turn signal illuminates and the sidemarker lamp will loose its ground, causing the sidemarker lamp to turn off when the turn signals are on and to illuminate again when the turn signal is off.
Which blub an socket did you replace ? check the other blub ? The switch and or the flasher module can cause this problem .
Replace the turn signal switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column.
Did you complete the replacement?
Oct 11, 2015 | 2001 Pontiac Montana
Sep 05, 2015 | 2001 Oldsmobile Intrigue
Jun 25, 2015 | Cars & Trucks
Nov 27, 2011 | Cars & Trucks
235 people viewed this question
Usually answered in minutes!