Question about Maytag 24 in. MDBH950AW Built-in Dishwasher
The handleto open the door has broken. I have the replacement panel which includes the controls. This part has a polyflex circuit ribbon. How do I disconnect the old part and reconnect the new circuit?
If the door is not latching well enough try adjusting the spring on the tub it's the male part that goes into the door latch. If that doesn't help you need to replace the latch. It's inside the door. The switch is mounted to the latch in the door so to get to it you have to remove all the screws around the outside edge of the inner door panel. Unhook power before replaceing latch or switch!
Posted on Apr 23, 2008
Hi thanks for the question. to repair . bottom kick plate must be removed ,to get to the door springs .4 screws . remove them. springs on each side . replace them thanks the appliance doc.
Posted on Oct 06, 2008
You definitely have to have a clean......float clean from all debris...it is very typical for the float to cause leaking problems ..as it is an overflow switch....also drying agents...that are used...especially if any is spilled inside will foam up and cause an overflow as well as liquid detergents that are not specified by the maker of your DW....these foam also....(if to much is used)...but the float will not push down on the switch if it is completely free from gunk.
I hope this helps.....good luck...thanks for rating my effort....the Fang.
Posted on Mar 29, 2009
A water softner will not make the dishes any cleaner, it just makes it so they don't have water spots on them.
If the dishes are dirty, it is most likely that the nozzles (holes) in arms may be plugged.
Also check to make sure you are getting plenty of water to dishwasher. Make sure all water valves are full turned open.
If the control panel does not work all the time, it is very likely you have either a shorted wire, or a fualty main board which is very common in newer machines.
Posted on Jun 01, 2009
handle was redesigned with a metal rod through the attachment points to prevent breaking. the handle and latch comes as a complete assembly (you don't have to put it together).
Posted on Jan 10, 2010
Tips for a great answer:
May 23, 2013 | Hotpoint-Ariston FDD914 24 in. Built-in...
May 19, 2010 | Dishwashers
Dec 20, 2009 | Maytag Dishwasher
Sep 18, 2009 | Maytag 24 in. DWU9202 Built-in Dishwasher
Aug 22, 2009 | Maytag MDB9600A Jetclean II Built-in...
Jan 09, 2009 | Maytag Dishwashers
Nov 17, 2008 | Maytag 24 in. MDB3700 Built-in Dishwasher
Aug 15, 2008 | Maytag 24 in. MDB9150A Built-in Dishwasher
May 07, 2008 | Dishwashers
Dec 20, 2006 | Maytag 24 in. MDB5600A Jetclean II...
68 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: