Our washer will go through the cycles to rinse, then go BACK to wash. What could cause this? We thought it might be due to the inlet screens being clogged since we have sandy well water. However, we couldn't figure out how to take the screens out. Is this possible? I have had to do just a drain and spin cycle a few times, so I know it can do it. Just can't figure out why it won't finish everything at once...or how to get the screens out. Please help. Only had the washer for about 2 months so it's brand new.
Hi,
Screen are to protect the valve from dirt and sand, you can clean the screens at the inlet to the washer but not advisable to remove them. If this is an ongoing issue you can call you dealer and ask for another set of screens to clean out at the hose connection to the wall, it could be easier to clean in the future. You can also call you local plumber for advise on how to prevent this from happening. Good Luck
I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249
55 views
Usually answered in minutes!
×