Question about JVC HD-56G787 Television

1 Answer

TV wont turn on. Only blue and red light flashes

Looked at the bulb and it looks fine. it is not shattered

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

You need to replace the power supply board. The new ones have a bigger heat sink - obviously JVC knows about the problem because they made the new ones bigger. It cost $250 from JVC and I installed it myself - took about 3 hours to do. If you are not tech savvy call a repairman. Hope this helps.

Posted on Aug 08, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Flashing green light


I have a mits. 82738 tv which would shut off after 20 minutes when first turned on .
Loose sound and picture.
Looked up error code in service manual and it said the lap was the problem.
Replaced lamp and now it works fine and the picture quality is great.

Jan 20, 2014 | Mitsubishi WD-82738 DLP TV

1 Answer

Samsung model hlt4675sx\xaa projection tv wont work. the stand by/temp light flashes red and the lamp light flashes green? it makes the sound that it makes when it turns on but no picture. we looked at the...


It could be the temp sensor going bad. This sensor sits on top of the metal housing which the bulb assembly slides into. The bulb assembly will have a hole on top and this is where the sensor is above. There is a small blue and white wire that plugs into it. If you pull the wire out and put a paper clip or wire in the coupling you will basically bypass the sensor connecting the blue and white wire. If your tv turns on then that is your problem. Its cheap too. Here were my symptoms..1] Turn tv on 2] Bulb would light up..(which eliminates the ballast) regular picture would show up (which eliminates the bulb and color wheel) 3] 30 seconds later tv would shut down with 3 flashing lights. After bypass the tv turned on as always and hasnt shut down yet. Always un plug tv first. Get the replacement part to avoid overheating and possible fire

Jul 31, 2011 | Samsung DLP HL-P5663W 56" TV

2 Answers

WILL NOT TURN ON. GREEN LIGHT; TWO RED LIGHTS


check the projectors lamp.look like to need replace

May 05, 2010 | Hitachi 60V500 60" Rear Projection...

2 Answers

I have a Phillips 50pl9126d/37 it wont turn on picture or sound blue light in the front flashes 6 times fast looked at the bulb and it doesnt seem broken ie( no glass bits inside broken off) otherwise...


I currently have this problem also. However my TV is blinking 6 times fast and then 5 times slowly. I was told by a TV repairman that it was in fact the bulb or lamp. I plan to replace it, soon, I will keep you posted hopfully it works.

Dec 11, 2009 | Philips 50PL9126D/37B 50" DLP TV

2 Answers

TV wont stay on.


Similar problem with my Sony. unplug for 36 hours and try again

Aug 13, 2009 | Samsung HL-R6767W Replacement Lamp

2 Answers

Samsung 50" DLP - Lamp Light Blinking after bulb replacement


Listen closely. The tv should make a high pitch whine as it turns on. If it does wait and see if it tries this a few times. If yes then check the bulb, I have seen cases where the lamp shoves the power connector back into the set. If the tv starts with a grown or heavy vibration noise, then your color wheel may have broken and needs replaced.

Jul 11, 2009 | Samsung HL-P5063W 50" Rear Projection HDTV

2 Answers

Bulb Replacement


It might be the the socket board on this model not the crt tube. Closely look at each tube these tubes end up contaminated. They start looking like lemonade inside. Usually the blue and green, with the tv off see if the green and blue are as clear as the red with a flashlight. You might want to call a service center. Cheaper in the long run over the cost of a tube.

Apr 17, 2009 | Philips 60PP9753 60" Rear Projection...

3 Answers

HLP5085W


If you look in the back of your tv, you should be able to see the light from the bulb, if the bulb isn't working no light.

Oct 12, 2007 | Samsung HLP5085W 50" Rear Projection...

Not finding what you are looking for?
JVC HD-56G787 Television Logo

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Televison & Video Experts

The Knight
The Knight

Level 3 Expert

73710 Answers

Jaime Hernandez

Level 3 Expert

2315 Answers

easy alberta
easy alberta

Level 2 Expert

132 Answers

Are you a JVC Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...