Question about XPLOSIV Age of Empires Collection

1 Answer

Installation problem the setup gets to 100% and stays there for hours and wont go to the end even on typical setup

Posted by on

  • 1 more comment 
  • tfortolu1 Jul 16, 2009

    thanks a lot my system is an intel(r) core(tm) duo t2350 @ 1.85ghx
    782 mhz, 2.00gb of ram
    microsoft windows xp
    professional
    version 2002
    thank for offering to help

  • tfortolu1 Jul 17, 2009

    i dont know how to check video card

  • tfortolu1 Jul 18, 2009

    thanks a lot, I ran all test ans it wass all successful,i dont know if this willl be of help to you, chip type: GeForce Go 7300

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 83 Answers

Hi

Can you tell me the following please;

Spec of your PC

the operating system

I will try to help you,

Many thanks

Steve :o)

Posted on Jul 16, 2009

  • Steve Smith
    Steve Smith Jul 17, 2009

    Hi,



    Thanks for the details,not a problem at all offering to help, i love this game too :),finally, can you please tell me what video card you have to please.





    I will try my best to resolve this for you



    Thanks



    Steve :o)

  • Steve Smith
    Steve Smith Jul 18, 2009

    Hi,



    Ok not a problem,you need to do this test first of all:



    Click the start bar,click run, type in the box 'dxdiag' then ok



    Click on the 'display' tab, this will tell you what video card you have, click on the 'test direct draw' and 'test direct 3d'



    The reason for this is it will tell you whether any of your drivers need updating.



    Let me know how you get on, in the meantime i will check out the AOE loading as i too have the explosiv pack



    Be patient i will resolve this



    Thanks



    Steve :o)



×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My watch stopping intermittently


When a quartz watch is no longer actuate with a good battery that means the movement needs a service (typically it's a bad circuit somewhere on the movement). It's fairly simple actually even I can do it and I'm not a horologist. Typically the service runs between $50-$100. Being that this may exceed the watches retail cost I would suggest concerning getting a new watch.

Dec 31, 2013 | Timberland QT7929201 Watch

1 Answer

Why my acer 4741G battery can't charge until 100% and stuck until 86% charge even I have to wait for 3 hours?it's already 1 year since i buy this laptop. Need more assistance, I hope for next, my...


Typical behavior of a faulty battery, cells are not accepting full charge... If its still under warranty, you can get the battery replaced no charge, otherwise you're in to fork out over 100 USD for a new battery pack.

:)

Aug 20, 2011 | Acer Computers & Internet

1 Answer

I have a compaq presario sr1430nx and am trying to install new hard drive. i got recovery dics and they install but computer is stalling on one-time setup process. just goes on for hours and hours.. Any...


Hi!
I worked with HP before, their computer hardware have what they so called "System Tattoo", this prevents the end users to change any hardware in the computer. You may try calling them at 800-474-6836. Hope this helps even a bit.

Apr 16, 2011 | HP Compaq Presario SR1430NX (PS566AA) PC...

1 Answer

Installed a new 625 today replacing any old 510 receiver. On the new 625 I cannot get TV2 to record--can only get TV1 to record. Have called Dish and was told to put in a DP separator. My husband did...


Hello! Dan Busa with Dish Network here. I know you've probably gotten this up and running by now but just for reference to anyone on this site. Any cabling or connectors used to carry signal to the receiver should be rated for 2,150 mhz if this is not the case you will typically get signal loss messages.

Oct 04, 2010 | DISH Network DVR-625 DTV Receiver /...

1 Answer

Security light is blinking on dashboard, car wont start, but you can take a screwdriver and jump the starter off and it will crank but wont stay running. it's a 95 buick lesabre limited. How do I reset the...


The security system (VATS/Passkey) installed on these GM cars is anti-owner more than an anti-theft. There are 3 parts involved:
  1. The chip-key
  2. The lock cylinder
  3. The TDM (aka the brain of the system)
if any of these parts fails or is even slightly malfunctioning, the car stays stuck where you are and you only get a dealer asking you about 1,000$ to fix it. And all the 3 parts have a quite short lifespan. Way too many people got in this situation (including myself). I don't recommend any partial solution or any used parts as it would happen again way too soon to be acceptable and if it happens 100 miles from home (like it happened to me....) it's a big burden. I finally made it to save my beloved 94 Park Avenue (with the same system that is installed in your car) with a solution that I found on the internet and that bypasses the entire factory security system, all 3 pieces altogether and you can even remove the TDM at the end and use 99c keys without chip. The product I used is at http://newrockies.com and is still working perfectly after 5 years. Don't go to the dealer!

Oct 02, 2010 | 1995 Buick LeSabre

1 Answer

Projector is saying to check the airflow? What does that mean?


This means you may have an obstruction preventing airflow from circulating properly. If this is the case, it can lead to overheating of the projector, which could result in very expensive repairs.

You need to regularly clean the air filter and rest the filter timer to ensure that your projector can cool itself properly. I recommend doing this every 100 hours of use. In fact, Hitachi projectors can be set to warn you when a certain amount of time has elapsed. I believe 100 hours is the default.

If cleaning the air filter and resetting the filter timer does not remedy this, you can use canned air to blow out the inside of the projector and try to clear the obstruction.

You also want to make sure all fans on your projector are working. If not, stop using the projector and replace those as soon as possible.

Overheating is the leading cause of projector malfunction, and basic routine maintenace can increase the life of your projector and the lamp by a great deal. For example, the lamps for that machine are typically estimated to have a life of no greater than 2000 hours, and typically you'll see them go out anywhere from 1300 hours to 1600 hours. Because I regularly check my machines, the ones that are not used intensively for hours on end every day will often have a lamp life of over 2000 hours, and I found one recently that made it to 3100 hours.

Sep 28, 2009 | Hitachi CP-S240 Multimedia Projector

1 Answer

Acer Aspire85 wont boot anything


You need to get into Bios Setup when the pc first starts.

I am not sure but I think the F2 key lets you into Bios Setup

The primary boot device needs to be the Cdrom drive.

The starting order for the pc needs to be set to
1st Cdrom
2nd HDD

You should then be able to install Vista.



Jul 01, 2009 | Computers & Internet

1 Answer

Problems during setup


if u're trying to install something from a CD , i think you should throw it , because it's not useful any more , in other case , if u're trying to install a software or a game or anything else on ur computer , try to download another copy !

Thanks .

Aug 31, 2008 | XPLOSIV Age of Empires Collection

1 Answer

1986 toyota landcruiser - auto box - quick chance setup kit for valve plate


Fitting an overdrive auto or a 5speed manual transmission will give a little more top end ......or..... fit larger tyres. V8 should have enough torque to cope well at lower speeds.

Jul 16, 2008 | 1986 Toyota Land Cruiser

Not finding what you are looking for?
XPLOSIV Age of Empires Collection Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top XPLOSIV Video Game Consoles & Games Experts

Vernon Taylor

Level 3 Expert

3408 Answers

EnergeeUK

Level 1 Expert

50 Answers

Lawrence Oravetz

Level 3 Expert

9639 Answers

Are you a XPLOSIV Video Game Console and Game Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...