Question about LG WM-2277HW Front Load Washer

2 Answers

LG front load washer A coin fell in between drum and housing.coin rubs on drum while spinning. how do you access the area between the drum and housing?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi Echucaellect,

Thanks for the insight. I have a Samsung front loader washer, and have the same problem. Can you tell me how I can fix and retreave the quarter/coin?

Thanks,

Posted on Sep 14, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 93 Answers

Take off the front panel

on the bottom/front of the drum is the heater- held in with 10 mm nut - slacken the nut- this will loosen the heater in its holder- pull out the heater- this gives you access to the bottom of the tank

Posted on Jul 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hello, I have a front load LG TROMM WM2277HB and yesterday it wouldn't spin anymoreand there was a noise coming from inside like 2 metal cylinders were rubbing on each other. I called SEARS Serv


if the machine fails to spin and makes noise there are thee things to check .if it fails to drain the water check if something is stuck on the drain pump no 2 turn the drum with your hand and check if the drum is moving freely if not something is stuck between the drum and the housing if the bearings are faulty the machine spins but makes alot of noise towards the end of the cycle i hope this will help you.

Jan 21, 2013 | LG 4775er2002a Door Hinges for Wm2277hb...

1 Answer

Noise during high speed spin cycle


sounds like the bearings need replaced, when replacing bearings you need to replace all of them to ensure proper function and life longevity.

Dec 11, 2007 | Kenmore 3.8 cu. ft. HE3 Front Load Washer

1 Answer

When spinning at higher speeds, there was a sound that could only be the drum hitting or catching something. The drum has now dropped about an inch. I took it all apart yesterday & could see nothing...


It's hard to give much detail without a model number, but it sounds like you are working on a front load washer.
If the tub of a front load washer has dropped down and is rubbing on the outer tube as it spins around then I would suspect the rear drum bearings are bad.
You can remove the back access panel from your washer and see if there is a trail of grease and water residue running down from the center tub bearing.

Aug 03, 2011 | Washing Machines

1 Answer

When in spin cycle it sounds like a bearing is going bad. It gets louder and louder.. Can the part be replaced? Is this a common problem?


Make sure that it is a bear problem. Have you thought that it might be a coin stuck on the edge of the drum that rubs on the washers main housing structure? Good Luck

Jan 07, 2011 | Whirlpool Cabrio WTW6600SBT Top Load...

1 Answer

Lg intellowash 7.5 wd1025fb. loud dry bearing like noise on spin cycle


could be a coin or something stuck around the drum area. check all areas around where it spins. get a magnet if you don't see anything visible and run it along all the area.

Aug 03, 2010 | LG TROMM WM2688H 4.0 cu.ft. Front Loading...

1 Answer

Spin cycle appears to be broken. washer just hums


Humming can indicate a stalled motor...If a coin is jammed in the pump impeller it will often do what you describe...Check via pump filter access door...Good luck....Nomess

May 08, 2010 | LG WM1814CW Front Load Washer

1 Answer

There is something in between the drum and housing. We have drained the washer and cleaned the filter still it is still there.


it seems like the drum will have to be removed to get to the offending object. it is probably stuck between the seal and drum, like a coin.

Aug 08, 2009 | LG WM2277H Front Load Washer

1 Answer

Front load washer- coin removal


Hi, The coin is probably inside the baffle that tosses the clothes around. I believe this nodel has a screw that holds the baffle in place. I hope this helps you. Please let me know if I can assist you further.

Thanks
Vic

May 28, 2009 | GE WSXH208A Front Load Washer

1 Answer

LG WM2077CW small item trapped behind drum


you would need to remove bottom exit rubber pipe from drum and use a flash light to free coin or screw,hope this helps

May 27, 2009 | LG WM2077CW Laundry XL Front Load...

1 Answer

Kenmore front loading washer - spinning problem


go to sears.com parts put in model no. and it will show you views of the parts and you can also order new dampner shocks from there

Nov 08, 2007 | Kenmore Elite 45986 Front Load Washer

Not finding what you are looking for?
LG WM-2277HW Front Load Washer Logo

288 people viewed this question

Ask a Question

Usually answered in minutes!

Top LG Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1460 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Are you a LG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...