Question about MGE UPS Pulsar Evolution 3000 XL (89349) UPS System

1 Answer

Won t work with new batterys

We replaced all 6 betteries with the same wiring routes as before, and now no lights come on the unit when it is plugged in. what coudl it be

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Check the big white battery power connector to make sure the metal tabs are making a connection to the female connection when pluging in the battery to the ups. If the tabs are not aligned the battery is not making a connection to the ups and will not engage the relays in the unit. Again check the metal connections in the male connector to make sure the flat tab is aligned with the female plug when connecting the plugs together. I could not get my ups to power up and the reason was because when I connected the battery the tabs in the plugs were not making a connection and the ups was not getting the voltage from the battery that it needed to power up the relays. I checked everything in the ups and then I looked closer at the battery connector to make sure the ups was getting the power form the battery and it was not electricaly connected to the ups because of the large white connector tabs were not aligned to connect to each other.

Posted on Nov 27, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does the battery light stay on. when ive already put new alternator and new bettery in car.

It could be the wire from the alternator to the ECM. Or the ECM has shorted.

Oct 10, 2014 | 2010 Chevrolet HHR

1 Answer

1992 toyota pickup won't start and battery won't charge

Sounds like your battery is just too dead, has enough juice to light up the system for a minute but cranking drains it and if it wont charge then deff fried, you could try removing the battery and starting the car with cables to confirm the starter still works. If a bettery is too dead then when you are jumping it, it takes to much of the power just trying to get through the battery.

Dec 21, 2017 | 1992 Toyota Pickup

1 Answer

Car was rinning perfect. One day it would not start. there was nothing, no clicking ,bell and guages were working. Jump start was nothing. Installed a new battery there was nothing. Went bact back 2 hours...

It sounds like you have an issue with your PassLock security system. I had the same with my 2002 Impala. Key turns OK, but won't start, won't crank. Wait 20-30 minutes, and car starts normally. There is usually a clue from the Battery and Security lights.
The problem starting to happen once a month, and eventually 1-2 times a week.
There are several write-ups on this problem for several GM cars for 2000-2006(?). Search this website, and search the web.
The official solution is to replace the ignition switch. The best solution is to bypass the Pass Lock system. I went ahead and did a full bypass, which involves cutting wires and adding resistors to the ignition circuit. I have not had a problem since.

Aug 19, 2011 | 2004 Chevrolet Impala

4 Answers

We bought duralast spark plug wires and they are not numbered and not sure where they go HELP

Remove one spark plug wire check length against new wires and replace . do this one plug wire at a time untill they are all done

Aug 13, 2010 | 1999 Chevrolet Blazer

1 Answer

Its not hitting right in the motor , its running on 5 cylinders when its a 6

Missing on a cylinder is always an ignition system problem. Replace plugs, plug wires, coil/distributor unit. Make sure your plug wires are routed right. Make sure timing is right. This should fix your problem.

Nov 26, 2009 | 1990 Toyota 4Runner

1 Answer

1997 Cutlass Supreme charging system problem

Check the bettery cables at the bettery and at the engine and stater, if they are corroded rusty or greasy, it will cause this problem. If there is corrosion at the battery replace the terminals with after stock from autozone. Also check the wires at the alternator to make sure they are also ok.

Nov 17, 2008 | 1999 Pontiac Grand Am GT

1 Answer

Hunter ceiling fan w/handheld remote. At times the fan will shut itself off and/or the light will go on by itself ( ie. no one has been near the wallswitch or remote)

1. check your bettery. put in a new battery. retry.

2. pull out the remote unit in the ceiling fan and check the wiring. be sure all wiring is securely wired together.

Oct 03, 2008 | Office Equipment & Supplies

1 Answer

My 1992 Buick LeSabre custom won't start at all. So where can I find the Fuse Box for the Alternator?

an easier solution to this is to disconnect the negative and/or positive battery terminal with the car running, if your alternator is working it will keep the car running. To find the wire that goes to bettery can be a PITA, so I reccomend going to an auto parts store and getting some 8 or 6 guage length of battery grade wire and connect that directly to the alternator and the positive end of the battery. I'd do this because you may have a faulty wire that doesn't keep the battery charged and it's hard to trace the wire route through the rats nest of wires it runs along with.

Sep 22, 2008 | 1992 Buick LeSabre

Not finding what you are looking for?
MGE UPS Pulsar Evolution 3000 XL (89349) UPS System Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top MGE Computers & Internet Experts


Level 3 Expert

79865 Answers

Jax Planet
Jax Planet

Level 2 Expert

922 Answers

Raj Patel

Level 3 Expert

917 Answers

Are you a MGE Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides