Adust screen brightness - Vtech DECT 6.0 Cordless Phone with Digital Answering System

1, Find the negative ground connection. clean it and reattach.

2. Headlights don't blow out like home lightbulbs, they start to die, they start to get dim. If yu are working with a two bulb system (one only comes on when you put high beams on) possibly the regular bulb is dimming because it is being used most.

3 try cleaning the globe to the headlight. Check to see if out of adustment. park car about 10-12 feet away form a blank wall. Turn lights on dim. Check to see if the "spot" created by the light is equal on both side. Older cars can lose their headlight "reach" making the bulb APPEAR to be dim when really, they need to be adusted.
it is very easy to adjust headlights.

With no further info, that's the best I can offer.

Their are adjusting screws in the light housing.look closely & you will find them.Turn headlights on pull up to garage door adust head lights

http://support.gateway.com/s/Manuals/Monitors/8512088.pdf
See pages 16 and 17. You will want to get to the picture menu in order to adjust the brightness.

try going to the setup screen button left of adjustments







try going to the set up menu on the left of the buttons come down to the slider control just above the information icon then go across to color reset hope this helps regards Jim

Hello Tim,
Sorry to answer u by this news :
this problem u have happening by 2 cases ..
1st Case :::: that's maybe ur screen lamps is broken ..so u can see the data but very dark or no Back-light .. so u will need to replace the screen..or advanced option but with expret person to change the lamps from another broken sceen,,
2nd Case ::::: The high-voltage board..it's small board built below the screen to give the screen the right voltage to light on .. so u will need to replace it also ..or Advanced option also but with expert electronic person to check it ..

best luck.

there,s some button hiden inside the tc. so ,you need to open it adust the brightness..but ,if your tv is too dark change the resistor value 680K at the CRT board . CRT board is a circuit that attach to the picture tube.

There are a few possible causes for this

-Picture tube has become weak after long useage
-A fault with the automatic degauss circuit could be causing the color problems.
-The color drive circuits may be out of adjustment.

I don't have instructions for you on how to fix this, I would recommend you either buy premium assistance or contact
another expert with long tv experience to possibly get details
on how to correct this problem.

I would recommend you contact your dealer for repairs if you have warranty. If you don't have warranty it may be cheaper to ask around.

well it all depends on where the tv is located to, if it is in a room with little or no light( windows, lamps) you will want you brightness to be a lil lighter hince not makin the picture as dark, and vise versa for light rooms, u'll wanna turn the brightness down a lil bit to accomidate this room, as for the others i'd say a lil over 50% on them, thats how my office tv is set up, hope this helps, jason

it's not the crt's themselves but more like the anode line coming from the crt. This will need to be taken out of their sockets and cleaned the metal tips on each. Yes it has high voltage in this area. So unplug and discharge whole set and still be careful.

the unit flyback has 2 adustments most likly one is focus the othercontrol on the unit g2 which if slightly adjusted will bump ur brightness up