Where is the ECM fuse and Fuel pump relay on a 2000 Hyundai Tiberon?

Here is the fuse box diagram, but the Elantra appears to have a rather funky battery fuse! Most vehicles have a main battery fuse but it is on the battery connector wire. If you put in a new ECM, was it programmed to the vehicle?

https://www.autozone.com/batteries-starting-and-charging/battery-fuse/hyundai/elantra-gt

Hyundai Elantra (XD; 2000-2006) fuses and relays

Fuse Box Diagrams https://fuse-box.info > hyundai > hyundai-elantra-xd-...

The fuse box is located on the driver's side of the instrument panel behind the cover. The location of the fuses in the passenger compartment: Hyundai Elantra ( ...

What engine ? could have 3.1 or 3.8 L No resistor ? for what ?
Noticed no Speed Cont. fuel pump relay. What are you talking about . Are you talking about no control for the fuel pump relay from the PCM/ECM engine computer ? The PCM Energizes the fuel pump relay for two seconds when key is first turned on . Two second prime of fuel system . When cranking the engine the PCM/ECM will only energize the fuel pump relay if it see's an input from the crank sensor .

Under the hood in the fuse and relay center.

That fuse ECM B also power's the fuel pump an fuel injectors ! It the under hood fuse / relay box ,pull out the fuel pump relay then put fuse ECM B back in an see if it still blows , You could have a shorted injector or fuel pump or the relay !

Check fuel pump relay.

If you have a four cylinder, the fuel pump doesn't have a separate relay, but rather its relay is built into the ECM relay. This relay is behind the center portion of the dash bolted onto the right side support bracket there. It's powered by one of the 30A slow blow ignition fuses in the underhood fuse block.

If you have the V6, there will be two separate relays on the above referenced bracket. The fuel pump relay should be the lower one of the two. For this relay, power originates at the 20A fuel pump fuse in the underhood fuse block.

Hyundai's online schematics are an excellent tool for this task. Simply register for an account at www.hmaservice.com. When inside, go to the ETM (Electrical Troubleshooting Manual) link in service information, select your year and model and MFI fuel system. The first page will show you the relay and additional information. If you click on the connector number for a component, it will bring up a separate window, in which you can click on links at the top to show a diagram of the connector, a picture of the component/connector, and a diagram of the wire harness in the vicinity of the connector.

Find the fuel pump relay, connect across the contacts from B+ to the fuel pump. This will make the pump run continuously. see if the engine stays running. It may be a bad relay or a relay feed circuit which is also run the the auto shut down switch. Lee

Look under the dash on the left side. You'll see the ECM (computer) under there. Right above the ECM, in fact hooked to it, is a plastic module that will have about 4 relays in it. From Right to Left there should be one relay with an extra opening above it, then a single relay (this is the Fuel Pump Relay), then a slot with 2 emptys and then a large relay on the Le

did you try to replace the fuel pump relay ?

check this spot. fuel pump relay is under the bonnet in the fuse box. it should tell you watch one it is