My icemaker is not working. Water not filling tray

Replace the water supply valve, it's only half working, its located in the bottom back with icemaker and dispenser water tubes going to it.

Greetings,

The first thing to check is the tube that puts water into the icemaker...this sometimes freezes up from a leaking water fill valve..if so, this blocks the water from filling the i/m....if its not frozen up and is clear(open) then your fill valve is bad or your icemaker module(if equipted) with that style...

Dual water valve solenoid not operational - or icemaker timer is failed.
Test both to verify which is bad.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Was the inlet tube frozen. If so your water inlet valve on the back where the water supply comes in is probably leaking and when the water reaches the freezer it freezes, blocking the inlet tube. Replace the water inlet valve.
You can Try swapping the wires on the dual water inlet valve. Then try the water dispenser. The water should go to the ice maker. This will tell you weather or not the ice maker valve is working and if the line is clear.

most likely the fill tube for the icemaker is frozen up you should see a tube running into the back of the icemaker. heat the tube up with a hair dryer until the ice is gone and you should be back on the road..

The filter is probably clogged. Turn off the water supply to the icemaker, disconnect it from icemaker and turn the supply valve on long enough to determine water is available. You say you hear the fill valve opening. The filter is the only problem remaining.

Ray

replace the icemaker fill switch in the icemaker its self its a micro switch behind the gold panel on the front of the icemaker

guest make sure your wire arm on icemaker is down same dandcs also for orig poster they have duel water valves one goes to door water one goes to icemaker. icemaker works a general rule more than door water so wears out faster but you have to replace both as they are a unit .other things that will stop ice production are frozen ice fill tube ,bad motor module in icemaker .check that first .if that don't solve it then reply to me and we will get deeper

It could be one of two things. The fill cycle could be too long causing the water to overflow or the icemaker may not be ejecting all the cubes out of the tray. A normal fill cycle is very short. Maybe 6 seconds long. So I would check and see how long the fill cycle is and when it stops check and see how much the tray is filled with water. I would also check and make sure that all the ice cubes are ejecting next time you hear it harvest.

It is possible that your icemaker tray is overfilling and the excess water is running out of the ice chute. There is an adjustment screw on the icemaker head beneath the large white cover which can be adjusted to compensate for this. If not then the icemaker head may need to be changed to correct this.