Question about Acer Wireless WIL-192 Keyboard

1 Answer

Acer cordless keyboard

Just purchased acer desktop and keyboard not working. every time a key is pressed or I try to use the built in mouse the battery light just flashes

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: acer cordless keyboard

How to activate Acer cordless itouch keyboard CE06781 ?

Posted on Jan 16, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

2 Answers

Logitech cordless keyboard not working properly - keys stick or are delayed

Did you spill something on it or is food lodged in unit if so take apart clean.
Fresh batteries would be good start.

Feb 18, 2010 | Logitech Cordless Desktop MX3200 Laser...

2 Answers

Getting full use of the keyboard

you may need to configure it. to do this, go to control panel, select "printers and other hardware, then click on "keyboards" and find your model.

Mar 28, 2009 | Logitech Wireless Access Duo Optical...

1 Answer

I can't set the date and time on my Logitech MX 3200 cordless keyboard. How do you do this?

1st, if your time display is not shown on the LCD, press FN and F9 at the same time until the display appear. Then press FN key and F10 key at the same time to go into SET mode. Use the arrow key to select and set your correct time. Press ENTER when done.

YBC (/\)

Jan 23, 2009 | Logitech Cordless Desktop MX3200 Laser...

2 Answers

Logitech wireless keyboard and mouse (ex 100) won't connect

The mouse and keyborard have to be in direct view of the reciever. Even a small obstruction will effect the operation

Nov 02, 2008 | Logitech Cordless iTouch Keyboard/Cordless...

2 Answers

Cordless mouse and keyboard wont work together

Hi, after experimenting a little i have fixed my problem and I think I might be able to help you.

First, try press the connect button on the receiver.. Hold it for 20 sec (might not be necessary).

Then, press the connect button on the mouse and hold it for 20 sec (is necessary)

Next, wait 20 sec (is necessary) then press the connect button on the receiver but do not hold

Finally, press and hold the keyboard button for 20 sec.

Sep 28, 2008 | Logitech Cordless Mouse

1 Answer

Hotkey problems

I had the same problem but finally found a solution hidden in the depths of Logitech. It's quoted below. I had to do it a couple of times before it worked, and it seems that you need to reconnect the mouse at the same time. I didn't the first time and then the keyboard refused to work. (Finger trouble?) :-(


The following is from :-

This article applies to the following products:
Cordless Access Duo
Cordless Acess Duo Optical
Cordless access keyboard
Cordless Elite Duo
Cordless MX Duo
Cordless Navigator Duo

You may be able to reset the keyboard and resolve the problem by clearing the keyboard capacitors. To do this, remove the batteries from the keyboard and type continuously on as many keys as possible for one to two minutes. This action should simulate touch-typing; you should not press and hold only some keys down.
After you clear the capacitors, replace the batteries and synchronize the keyboard using the following procedure:
  1. Make sure the batteries are in correctly. A diagram on the device itself or in the Getting Started Guide should tell you the correct polarity for the batteries.
  2. Press the connect button on the receiver.
  3. Press the connect button on the bottom or right hand edge of the keyboard.
    NOTE: If you are using a Cordless Desktop System, you must do this procedure for both the mouse and the keyboard.
The "Connect" button on the mouse is quite small and usually requires a pencil tip or other small object to push it. Remember, ALL Logitech cordless devices will have a synchronization button. If you have the "Cordless Mouse" with Model Number (M/N) M-RN67, the button will be located in a small hole on the lower portion of the back of the mouse. You will need a paper clip to access the button.

Jul 03, 2008 | Logitech Cordless iTouch Keyboard/Cordless...

1 Answer

Logitech cordless mouse and keyboard installation

You probably already done this but try pressing the receiver button and while it is flashing turn the board over and press the small reset/connect button on the bottom of the board and also the reset/connect button on the bottom of the mouse. It should work okay after that. here is hoping that helps. Bud

Dec 20, 2007 | Logitech Cordless Desktop MX3200 Laser...

1 Answer

MX 3200 Cordless Laser Keyboard - Logitech

Press the FN key and *at the same time* press the F10 key for 1 second.
The first part of the time should start to flash.
Use the up / down keys to change the hour, then press TAB. The minute figs. should now flash. Use up/down to change the minutes and press TAB.. do the same with the date and month etc, you can also set 12h or 24h clock.
When you are finished press ENTER.

Nov 24, 2007 | Logitech Cordless Desktop MX3200 Laser...

1 Answer

Logitech cordless desktop EX110 keyboard

Normal 0 Turn the mouse over and find the small rest/connect button on the bottom of the mouse and press it. This should connect the mouse to the receiver and work properly. If not, try pressing the receiver button and then press the button on the mouse. This should be done whenever you change batteries or glitch.
Hope this helps you. Bud

Oct 31, 2007 | Logitech Cordless Desktop EX110

Not finding what you are looking for?
Acer Wireless WIL-192 Keyboard Logo

902 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acer Keyboards & Mice Experts


Level 3 Expert

18258 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you an Acer Keyboard and Mice Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides