Will not stop running - Asko 24 in. D3250 Built-in Dishwasher

https://www.youtube.com/watch?v=9HsNbDcJgkU
A treadmill that stops running after starting the workout can mean something is wrong with the belt, platform, motor or speed controls. When too much resistance occurs during a run or walk, the treadmill stops running to avoid any damage to the motor. https://www.livestrong.com/article/35127-troubleshoot-treadmill-stops/

Not knowing what brand or type it sounds like the advancing motor stopped. You should bypass it and call a service tech.

your door is not staying latched.. imagine if it did stay running and the door came completely open, what a mess that would be. so there are safety switches that help stop the washing if the door opens. not too sure how to fix your exact washer.. but the problem is the door not staying closed. maybe you can jamm the door shut while it is running? its not the best answer, but probably the most free way to fix it

Well, I'm not sure about the colors because you didn't tell me what year model bike you're working on. But, in the earlier models, up to 1999, the power for the start switch came directly off the "Run/Stop" switch. This is designed to keep you from running your battery down because the run/stop switch is in the "stop" position. If you run/stop switch is in the stop position, the starter doesn't have any "fire" to it and it won't turn the engine thereby telling you that you have something wrong. The old Shovelheads had a "Run/ Stop" switch in 1973, when it was in the "stop" position, I saw many batteries run completely down trying to start the bike. Harley rewired the switch so that the "Run/ Stop" switch had to be in the "Run" position in order to get the starter to work.

Good Luck
Steve

Mower stops running after mowing about 5 minutes. acting like it was running out of gas unitl eventually stops. I wait 10 minutes and then it restarts, runs good, then erratic...then quits again?

check whether the power saver mode is on. put it off. or some timer must be on. stop the times. it wll be rectified

If its the 3.0 diesel it could be the rail oil pressure sensor starting to pack up .

Are you sewing or embroidering? If you are embroidering, the machine automatically stops and shows scissors in the window, for you clip the jumpstitch. Then just push the "Run/Stop" button.

It might have a small stone or something similar in the water soleniod valve or it might just be sticking open somewhat. I'd go ahead and change the cold water soleniod valve because it's not closing itself and shutting off the water flow.