KEEPS ASKING TO GO INTO STAND BY MODE WHY? - Televison & Video

mine is doing this too, i called Magnavox support and they aid it is an internal power issue and cant be fixed by troubleshooting, it has to be serviced. imo, probably cheaper to buy another.

Recheck your remotes settings most likely it's turned on for stand by sometimes going into your settings and going back to it's default settings helps.

It sound like the TV has gone into stand-by mode...
Try pressing one of the channel buttons, like the channel up or channel down button. That should bring it back out of stand-by mode.
Hope this helps :D
Any more questions, just ask!

the Ec message is reffering to the mode the tub is set for. Ec stands for Economy mode. In Economy mode the heater will only come on during the filter cycle you have programmed. It will take a while for the tub to actually heat up in this mode. Change the mode to St mode which stands for Standard mode. Your manual should explain how to do this. usually you hit the temp button then the light button to change from mode to mode. Once the St is in the read out window don't touch anything and it will except the programmmed entry automatically. In the Standard mode the tub will keep heating until the set temperature is reached. then it will come on every half hr or so to check that the temperature is maintained.

Given the heat/cold cycles of the storage area along with humidity, I would first suspect poor solder connections. This is not unusual for units of this age. A general overhaul should restore this to operation. This should be a labor only repair unless the output STK is bad. These units are known for having poor connections at the voltage regulators which cause a DC voltage offset triggering the protection circuit. The overhaul should address this as well.

Keep us posted on your progress.

Dan

dear ...u need to rate me for this ok ....

actually i want to ask u that when you are doing white balance is your camcorder in recording mode ?
if, yes then dear camcorder will not take white balance in recording mode .. make itin stand by mode and then do white balance by keeping a white paper in front of the camcorder at least two meter away ok.

dear,
did u try it by switching it off and then on after some mins..
if not then do it...best way to keep it without battery for some mins and then try again

regards

ask if further required...

I don't believe it is stuck in the sleep standby mode, rather it has shutdown with an error. Is there a pattern to the flashing? Does it flash a set number of times?

I went back and rechecked. If the fan mode is selected, you can only set the fan at one of the three speeds. If you leave it in the fan mode, the dehumidifier will not come on.

Once the fan speed is selected, it will run at that speed in the dehumidifier mode. The fan will keep running, even when the dehumidifier (compressor) shuts down.

The only way to get it to turn off is to use the clock setting, which either selects how long it stands-by before starting , or how long it will run before going back to stand-by. DeLonghi calls it "stand-by," we would call it "off." DeLonghi calls unplugged "off."

I've never turned mine to stand-by, because it will never get my entire house down to 30% humidity (I have it where my air handler returns air to the basement). I live in the greater DC Metro area, where 75% humidity is considered extremely dry.

Apparently the normal mode of operation is fan on unless awaiting a clock start, or encountering a clock shut-down; either condition puts it into the "stand-by" mode.

Do you wanna repair it by yourself? How many times stand-by light flashing?