Question about Danby DWC283BLS Wine Cooler

Open Question

Changing temp controls

Power went out so temp setting went back warmest setting. When we push the buttons to lower temps, they flash but go back to the higher temp settings. We can find the manual so how do you change the temps to stay at the temperatures you select???? Thank you to anyone who can help.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 146 Answers

SOURCE: Three Temperature zones

Did you read the owners manual? It will be kind of hard to tell you because there are so many different settings for different areas.

Posted on Dec 26, 2007

Ad
  • 4 Answers

SOURCE: danby kegerator not cooling

I just had the same problem. Mine was outside on the patio and the key pad on the front was the problem. cost me $2.27 plus shipping and it took me 5 minutes to fix call Danby back and wait on the phone for their parts and tell them you need the keypad sticker. Good Luck

Posted on Aug 07, 2009

  • 1 Answer

SOURCE: Digital Temp Controller Problems

I unscrewed the top plate, removed 2 screws on circuit board for display, removed the ribbon tape and pulled off the front digital display(stuck on with sticky tape) and then replaced the same display unit and the buttons are working now... going to search online for new display.

Posted on Sep 12, 2009

  • 1 Answer

SOURCE: Accidental defrost

I did the same thing. I know it's a little late now but for anyone that does this again here's what to do. There's a thermostat in your actual freezer you might not be able to see it, because it might be covered in ice. It looks like a tiny tube, To stop the defrosting all you have to do is warm up the thermostat either pressing a hot towel agaisnt it or meltling the ice with a dryer (but be careful)! After a minute or so the red button should pop out again and the refrigerator will start humming again. Unplugging the refrigerator will not reset anything and don't try to pop the red button out of your own!

Posted on Oct 13, 2009

  • 1891 Answers

SOURCE: Set temp to 42 and

sounds like the compressor is not running . ck the connectons at compressor and listen for a click in the cold control as it may be bad .. / noises like clicking at compresor . may be the relay that starts it .. mm

Posted on Aug 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my samsung refrigerator is the higher number coldestor warmest


If you push the freezer temp button the display on the freezer side will show set temp for freezer and after a few seconds it shows actual temp. Same thing if you push fridge side.

Aug 06, 2018 | Samsung Refrigerators

1 Answer

Drying time increased


you may need to check your heating element in it.

Oct 17, 2013 | Maytag Neptune MDG5500AW Gas Dryer

1 Answer

I can't turn my Kenmore upright freezer on.


Try disconnecting power for about 30 seconds, and then restore power. This will reboot the control and maybe restart.

Jul 09, 2017 | Kenmore Freezers

1 Answer

The temp setting is on 4 for both the freezer and refrig. Which way do we set the temp controls to warm up the temp? Is the lower setting warm or cold?


Good day,
The higher the number the colder the temp. 1 being the warmest.
It takes 12 to 24 hours to realize a new setting's effect. Go slow.

Apr 26, 2010 | Whirlpool Refrigerators

2 Answers

Temp Control


Hi!!

The higher the number, the colder the setting.

Rate this post, Good Day!!

Apr 26, 2010 | Haier 5 cu. ft. / 142 liter Chest Freezer...

1 Answer

True cooler frezzing kegs of beer


If I am not mistaken, the True line-up of coolers have a temp control on them that is labeled 0-9.

This particular type of temp control is a coil temp control. I measures the temperature of the coil rather than air temperature.

Always set the control to the warmest setting and move it colder by one number at a time until your product reaches and holds designed temp. Do not go by cooler air temperature as there will be a great swing in temp especially if the doors are used frequently. Always temp the product. In the case of beer, your ideal holding temp is between 35-38°.


If you set the temp control to the warmest setting and the cooler is still freezing product, you will need to have the cooler serviced be a refrigeration tech. It will most likely be a bad control but there may be underlying problems.

Jan 08, 2010 | True TBB-2 Beverage Cooler

1 Answer

Burners shut down at set temp but fan continues lowering temp


the reason he told you not to cycle the power is because some where there is a flashing light that he can decode and tell him where to start looking for the problem. Call him next it happens and don't touch the power or the stat until he gets to see the unit.

Aug 03, 2009 | Heating & Cooling

1 Answer

When I change the temp. setting it keeps heating at original temp


The keypad appears to working correctly.

When you alter the set temperature via the keypad the display will flash the temperature thats to be acheived, once it stops flashing the keypad will revert back to the current temperature of the water.

Hope that helps,
Ian.
http://hottub.synthasite.com

May 24, 2009 | Balboa Instruments Duplex Digital Panel 2...

1 Answer

Control Display keeps changing numbers


we unplugged the refrigerator for a bit over 1 minute and replugged and problem went away.

Jan 11, 2009 | LG LRFD21855 Stainless Steel French Door...

Not finding what you are looking for?
Danby DWC283BLS Wine Cooler Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Danby Furniture Experts

Charles T Nevin
Charles T Nevin

Level 3 Expert

4070 Answers

Dennis Boxerman

Level 3 Expert

1266 Answers

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Are you a Danby Furniture Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...