Hi i lost my key for my 2001 venture and i damage the ignition key, how can hotwire?

If you do not have the key fob, then you will not be able to start the car by hotwiring it. If someone tried to steal it, then you should be covered by insurance.

no hotwiring is movies need to order and repair damaged component

you dont no by-pass/hotwiring ign system ---have new key cut using vin from dealer or an auto authorized locksmith --cheaper than replacing ign or doing damage that will cost more

Go to a breakers yard and get a new ignition key and lock. Hotwiring a car is not as easy as they make it look in the films. You have to get power to the ignition circuit, you also need to light up your dashboard and stuff which is key dependent. When you have done that, you have to energise the starter motor and stop it when the engine fires. And talking of fires, they can happen during hotwiring!

otherwise see this video about a hot wire
also be warned this must be your car in your name or you could be committing a criminal act by performing this service How to Hotwire Car

Not recommended, could damage other related circuits.

cant hotwire your vechicle has the PATS SYSTEM.your keys has transponder on it.the ignition switch antenna ring and immobilizer control module and ECM read signal emitted from the keys transponder if you have no keys or wrong keys the PATS SECURITY SYSTEM DISABLE IGNITION SYSTEM CAR WONT CRANK.CANT HOT WIRE CAR WITH THE PASS KEY SECURITY SYSTEM.older cars back in 70s you could hot wire newer cars you cant.

FIXYA ADMIN CHECK. Q APPROVED.

hotwiring will not unlock your ignition which also controls your steering lock perhaps you can call the dealership and have the courier a key will cost you more but it may still be better for you they will ask you for vin number and perhaps proof of ownership it cannot hurt to call and ask

You must get a new key from the dealer. Bring in the registration, and photo I.D. Then they will cut you a key. After that, try this procedure....

1. With a master passkey III key (Black), turn ON the ignition, with the engine OFF.
2. Observe the Security telltale, after approximately 10 minutes the telltale will turn off.
3. Turn OFF the ignition, and wait 5 seconds.
4. Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes.
5. With a master passkey III key, start the vehicle. The vehicle has now learned the key transponder information and the PCM has now learned the fuel continue password.
6. If it does not work, you will need to get it to the dealer.

GM technicians on-line