Question about Car Audio & Video

5 Answers

How do i wire an equalizer without any wiring diagrams

Got no idea which wires go were

Posted by on

  • 8 more comments 
  • mgarner01 Feb 17, 2008


  • meader Apr 25, 2008

    I need the 3pin wiring diagram.

  • Anonymous May 15, 2008

    confused as to where appropriate wires should go

  • Anonymous Aug 29, 2008

    no digram

  • zerbel Nov 21, 2008

    i need wiring diagrams

  • zerbel Nov 21, 2008

    i need wire diagram

  • Anonymous Dec 16, 2008

    pioneer eq 6500 2 blue wires / plus red and black. where do the 2 blue wires go/which one to where?

  • Anonymous Dec 17, 2008

    eq 6500 red wire,black wire,two blue wires one which has a fuse. What for what? thanks.

  • bignut97 Jan 19, 2009

    i heve an alpine 2 amp 7 band equalizer that is greek to me i need some help please

  • Anonymous Mar 08, 2009

    two sets of rca cables lr lr coming out of head unit but only one set on the 7 band eq 2 into 1 rca"s or can i bridge at the head unit



5 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

1. bottom right( red wire 12 v dc on/off ignition switch)
2. top right( blue wire with inline fuse to amplifires)
3. bottom left( black wire ground)
4. top left( blue wire stereo remote wire)
I have a pdf photo diagram I made just e-mail me and ill send it to ya. hope this helps

Posted on Mar 25, 2009

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Red wire w/fuse = Positive for 12v
Black wire = Ground
2 Blue wires = Remote lines to power on the amp(s).

The amp(s) can be turned on via the button on the eq6500.

Posted on Jan 13, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 93 Answers

Do u have the model number

Posted on Nov 16, 2007

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

How to conect my mobile aux to proline gp- 870x2 I dont now how

Posted on Sep 25, 2015

Pioneer eq 6500?? please help....need wire color code

Posted on Jul 20, 2008

3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Purchased an alpine 3011 graphic equalizer that

You are going to need the DIN plugs for the unit, on the back there are two imput jacks. The left jack is for the imput from your head unit, as far as I know, there is no other way for the EQ to accept imput except for the jack. The right one is for a digital time delay unit (rare). Coming out of the unit there are two output jacks, one is line out front, the other is line out rear. With these, there are also your power, ground, remote power, and speaker out puts. Good luck. I had one of these back in the 80's.

Posted on Jan 01, 2011

  • 1 Answer

SOURCE: how do i wire an equalizer without any wiring diagrams

how do i hook up my equalizer color code info

Posted on Jul 15, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My truck battery is going dead n i have tested n discovered that it is through the oxegen sensor wiring. i have unplugged all three sensors n still have the drain. any ideas what to do next?

have you had a load test done on the battery. batteries die in cold weather. If it is going flat after disconnecting the sensors then obviously that was not the fault. If the battery proves good disconnect the earth wire to the battery ,put an amp meter in the circuit and get an idea of the current flow . That will give you an idea of the size of the unit drawing power.

Feb 03, 2015 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Wiring diagram for BOSS AVA 1209 equalizer. It was given to me dont know where the 4 wires connect red,black,white,last wire is orange or pink.

Your wiring is as follow's :

The Red wire is your (+) Positive that connect's to the power source
The Black wire is your (-) Negative that connect's to the ground
The Orange wire is your Auxillary (+) that turn's on Amplifier's or Power Ant.

You should have a Green wire, a Green wire with a White stripe,a Gray wire, and a Gray wire with White stripe

The Green wire is the LEFT channel input (+)
The Green/White wire is the LEFT channel input (-)
The Gray wire is the RIGHT channel input (+)
The Gray/White wire is the RIGHT channe (-)


PS. I have no idea where that White wire you mentioned goes.

Feb 03, 2011 | Boss AVA1209 7-Band Car Equalizer

1 Answer

Wire diagram for hifonics triton eq

well their are 3 outputs if they have been rewired. Don't worry it will say acc+,ground,remote.just look it at edge of your equalizer.

Jan 05, 2010 | Hifonics HFEQ Car Equalizer

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

4,310 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4905 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers


Level 3 Expert

78010 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides