I noticed it does not heat as well this year as when i bought it last dec. Now when i push the on button nothing happens. When i push the button more than once both lights flash, but still noyhing.
my heater is not working and my honeywell RTH110B thermostat has an arrow pointing to the...
(More)
my heater is not working and my honeywell RTH110B thermostat has an arrow pointing to the temperature.
Heater on level surface, when plugged in heater will heat for 3 to 5 minutes then shuts off and does...
(More)
Heater on level surface, when plugged in heater will heat for 3 to 5 minutes then shuts off and does not turn back on
Hi, Morphy Richards Electric Blanket, not working, no neon. Using a multmeter, it looks like the...
(More)
Hi, Morphy Richards Electric Blanket, not working, no neon. Using a multmeter, it looks like the first component has failed. Totally blocks the AC, cannot identify it. Is it some kind of resistor or fuse (looks like a long white resistor with no markings)? Thanks.
How to replace the power cord on a Honeywell Ceramic heater model #HZ-341BL? Does the grille have to...
(More)
How to replace the power cord on a Honeywell Ceramic heater model #HZ-341BL? Does the grille have to be removed in order to access the screws beneath? And if does, how is it removed? Gently prying doesn't work.
I bought a used HZ-510. It seemed to work fine pre-purchase. After getting it home, it cycles off...
(More)
I bought a used HZ-510. It seemed to work fine pre-purchase. After getting it home, it cycles off and on. On about 1 to 3 min and off 3 to 5 min. I removed the cover to diagnose the problem. I cleaned the temperature sensor located right over the ceramic coils, it had a small amount of dust. The thermostat seems to operating properly as it calls for heat and stops calling when it is turned down or is satisfied. The fan is operating, the blades are clean, the coils are clean. I see nothing that would indicate improper air flow. The only thing that is throwing me is what apears to be a temperature sensing device on the thermostat knob itself. With the pendulum type wighted cylinder that opens the contact. It is getting hot to the touch, is there a desighned temperature it is supposed to reach and not exeed? I understand that being purchased used and not being the original owner it may not be under warranty. Any ideas as to what is the problem and where to get parts if needed? By the way, I am a heating and air conditioning contractor in NC if that makes a difference.