Question about Fuji FinePix S2000hd Digital Camera
Hi...my s2000 HD has got stuck for some reason...while clicking the pictures, the power just went off, the lens is still out. I checked the batteries, but even they're charged...after several attempts of removing the card, restarting the camera etc, only some flashes of light came on the screen but the lense is still out...please help me with this problem...the camera is only a couple of months old
If memory card is not locked.... then i think ur card get corrupted... so u should replace ur memory card.....
Posted on Jul 12, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Apr 21, 2015 | Cars & Trucks
The following conditions will cause the Protection LED to go on:
• Initial power-up: For approximately five seconds after initial power-up, the
protection circuitry is activated and the speaker output is muted. If everything is
operating normally, you will hear an audible click at the conclusion of this brief
period, as the protection circuitry is deactivated and the S1500 / S2000 begins
delivering signal to connected speakers (at which point you'll hear a click). It is
normal for the Protection LED to fade gradually after the amplifier is powered off.
• Overheating: A temperature sensing device in the S1500 / S2000 will cause
the protection circuitry to be activated (and the Protection LED to go on)
whenever the operating temperature of the unit rises above a safe level. To
guard against this problem, make sure the S1500 / S2000 receives adequate
ventilation on all sides and that both the front and rear panels are unobstructed.
• Severe overcurrent conditions: This occurs whenever the signal being input to
the S1500 / S2000 rises to a level above 20% THD (Total Harmonic Distortion).
• Shorted speaker cables: This will occur if, due to faulty wiring, the hot and
ground signals being output by the S1500 / S2000 short one another.
• Output impedance drops below 2 ohms: This can occur if the S1500 / S2000
is connected to inappropriate speaker systems (see the "Setting Up and Using
Your S1500 / S2000" section on page 5 in this manual for more information).
• DC voltage detected at speaker output: The most likely cause of this is an
In general, any time the Protection LED lights up (other than during the
approximately five seconds following initial power-up), there is reason to be
concerned. If this occurs, turn the S1500 / S2000 off immediately and carefully
check all wiring and external devices in order to locate and correct the condition
that caused the LED to light up in the first place.
For further assistance, contact your local Samson dealer. If purchased in the
United States, you can call Samson Technical Support (1-800-372-6766)
between 9 AM and 5 PM EST.
Feb 07, 2011 | Crown XTi 2000 2-Channel Amplifier
Sep 06, 2010 | Sony CDX-S2000 CD Player
Nov 27, 2009 | FUJIFILM Finepix A200 Digital Camera
Nov 07, 2009 | Sony CDX-S2000 CD Player
Jul 06, 2009 | Fuji FinePix S2000hd Digital Camera
May 03, 2009 | Fuji FinePix S2000hd Digital Camera
Mar 09, 2009 | Fuji FinePix S2000hd Digital Camera
Oct 23, 2008 | Sony CDX-S2000 CD Player
150 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: