Heats but drum has stopped rotating - Abbaka White Knight WK77AS Dryer

there is a capacitor next to the motor.......

needs replacing....

cheers

sounds to me like a defective push start button. probably stuck on the on position

fan belt not working - replace it

Sounds like the belt that turns the drum has slipped off or broken. Not sure if I would consider this a DIY project, but if this is the problem, a professional fix should not cost much.

Hi, If you are having problems with your gas dryer not heatingthe most common problem is that the ignitor goes bad. Even though it glowssometimes it is still not working properly. if you dryer is gas check out this gas no heat tip.... If you have an electric dryer, you can have many differentthings that can go wrong causing the dryer not to heat. check outthis electric no heat tip...

heatman101 ,..,

it should unless your model stops the drum for rack dry. More than likely your motor quit or your belt broke

if it fill with water then stops it is the ellement the machine first fills turns the drum then heats up the thermostat cuts in and the it emptys rinses and spins so if it does not get to temp it will stop or continue to wash forever

check capacitor next motor its a white long got three clips coming off it change good luck

shaun

power pack, or condensur is faulty that stats the motor fit new one .close says!

If your dryer doesn't tumble, check these:

Belt
Motor
Door switch
Belt Dryers have a drive belt that turns the clothes drum. If the belt breaks, the drum stops rotating. Then you need to replace the belt, and often the idler pulley, because the pulley tends to wear out at the same time.

Click here for a belt installation diagram.

Motor If the dryer motor only hums when you press the Start button, the motor may be burned out. Here's how to test the dryer motor:

• Remove the belt.
  
  
• Check for obstructions in the blower fan housing.
  
  
• Manually rotate the shaft of the motor.
  
  

If the motor is very stiff, or impossible to rotate manually, and the blower fan housing is clear, you need to replace the motor.

If the motor rotates freely, run the motor momentarily with the belt removed and the blower in place. If the motor runs fine with the belt removed, there may be a problem with the idler pulley or the clothes drum. Try to rotate the drum by hand. If it is very difficult to move, correct any problem with the rollers or pulley, and then reassemble the dryer and try it again.

If the motor hums but doesn't rotate on its own even with the belt removed--yet you can turn it freely by hand--you usually need to replace the motor or the motor start capacitor.

Door switch Your dryer can't operate at all if the door switch is defective. It's inside the dryer main housing near the door frame. Sometimes you need to raise or open the top or front of the dryer to reach the switch. If it's defective, you need to replace it.