Question about Dryers

1 Answer

Hotpoint CDT00 Tumble Drier has No Heat

HiI have a Hotpoint CDT00 and the heat has stopped all of a sudden. It still works and blows air but its cold. An ideas? Thanks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 89 Answers

You need to check the heating element also check the front drum supports they ussually wear out causing the tub to rub the element this causes the element to burn into

Posted on Jul 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No heat but blows cold air


Sound like 1 of a few things. The easiest is air in the cooling system. Bleed it and while car is idling and heat is on full blast. (another posibility is head gasket gone bad)

Dec 09, 2013 | BMW X5 Series Cars & Trucks

1 Answer

Hi I've Got A Hotpoint Aquarius CTD40 Tumble Dryer


that isn't a model number,open the door to the dryer,look around the opening where you put the clothes in and send the full model number,

Dec 21, 2017 | Hotpoint Dryers

2 Answers

Air conditioner suddenly stops blowing cold and starts blowing heated air. Control panel indicates that it is still on air conditioner. Switching the control from vent to cold does not have any effect. ...


If you are absolutely confident the AC compressor is not kicking out on low pressure then it is the blend door actuator.

The blend door determines how much air blows through the heater core or evaporator.

The actuator can be purchased at dealer and maybe at a local part store.

May 27, 2010 | 2005 Chevrolet Avalanche

1 Answer

Chevy astro van heater blowes only cold air


the problem is probably the heater core, it can become clogged with dribris. this stops heat from the engine getting to it and then no heat.

Dec 08, 2009 | Chevrolet Astro Cars & Trucks

1 Answer

2003 Saturn L200 - Suddenly stopped blowing cold air


If it happened all of a sudden, check the fan belt, and the A/C fuse. These are the most likely culprits. If the fuse is blown, the clutch on the A/C compressor may have gone bad, and should be looked at.

Jul 28, 2009 | 2003 Saturn L-Series

1 Answer

CDT00 Drying takes ages, water tank does not fill


check all seals are clear and free from dirt, also there will be a heat exchanger (usually located above the sump) this must be clean and free from dirt this does all the work so if the area is not clean it will take longer to dry.

Dec 11, 2008 | Dryers

1 Answer

Carrier Weathermaker 8000 - furnace does not ignite


having a problem with a weather maker 8000. It will not come on at all unless I shut down the switch on the side of the furnace. filters is clean. it will start to light then stop

Dec 10, 2008 | Heating & Cooling

1 Answer

Hotpoint condenser dryer CDT00


how to connect the dryer belt to the motor is there is two pullys.

Mar 30, 2008 | Dryers

3 Answers

Hotpoint condenser tumble dryer aquarius cdt00- wont dry


I am not familiar with this particular unit, but I have a condensing dryer (Malber) which pumps out the water by itself. I am guessing that your unit requires you to empty a bin manually. Even if the bin is empty, I think the unit thinks it needs to be emptied and that is why the dryer will not work to give you hot air. If you do have such a bin, it might have a weight switch which the unit uses to detect if the bin needs emptying. See if the weight switch is working. The same weight switch idea is used on dehumidifiers.

Mar 09, 2008 | Dryers

1 Answer

Hotpoint Condenser Dryer Model CDT00


Either your heater is blow or your thermal cut outs are blown easy to check and replace ...

The are located at the back of the dryer behind the protuding funny shaped panel...

Check the continuity on the t-stats if no present then replace both of them small round things
then its the heater....

Jan 19, 2008 | Dryers

Not finding what you are looking for?
Dryers Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dryers Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Brad Brown

Level 3 Expert

17446 Answers

Are you a Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...