My heli wants to fly foward as soon as it takes off. iv tryed allot of suggestions. whats my problem? cant cotrole it alt all.

If I understand what you're describing, the heli will fly properly at the start of each flight then becomes non-responsive and crashes. When you begin again, the same thing happens.

If that's correct, then it sounds to me like the heli is flying out of range of the transmitter. Check the batteries in the transmitter. If the batteries are ok, then check the distance to be sure you're staying within range. If you are within range, are you remembering to turn on the transmitter before connecting the heli battery? Did you properly bind the heli to the transmitter? Any other flyers in the area that could be causing interference? Power lines nearby?

Another thing, if it does fly out of range, and if your heli is properly trimmed, it should stop and hover. If it's not doing that, then check that your controls are in the proper position before connecting the battery.

Hope this helps.
Randy

Please remember to rate my response.

Hi,
I have similar problem with my LS-208 heli.
Helicopter leds are blinking red/green, front white led is on, and tail leds are blinking too.
Remote controller red led is on as should be but helicopter doesn't respond to controller at all.
I followed instructions above with no success.
Anyone has a suggestion?
Regards, Yaron.

battery need to be replace charge life is over

r u charging from the controller? if so put luthium aa batterys in controller the ones you have in there now may not be giving a full charge, you r turning the controller on when charging heli right? wait for the chareer light to turn back to green from red will tell u charge is done. u must have a computer 2 have posted this so charge ur heli from computer wait 4 it 2 light up red (the usb plug) b sure heli is off when charging the little swith should b forward toward nose of heli if it still wont lift off after a good charge b sure the top part of the blades are tight on shaft, its the two screws just under the top blades 1 of the 2 must b tight on the shaft or it wont get enough power if it is slipping, if it still wont lift off u may have a bad li po battery never run it way down!! always stop flying when u c the heli start to not have enough power to hover, always stop and let batt cool dn then charge, then after charge try 2 wait 4 a little bit b 4 flying 2 let batt cool from charging, i know it is very hard 2 wait, hoppfully u have not fryed the battery if u still cant get it e mail me and i will help u get up and flying good luck the s 107 is my main bird i work on them 4 friends all the time if i had it 2 look @ u would b fly n n 5 mintues my e mail is [email protected]

you should have charged your heli BEFORE 1st flight.......anyway,,plug computer end of usb charge
cord into computer......turn heli OFF....before you plug cord into heli look at computer end of cord,,
should be bright red light inside......now plug other end of cord into heli.....bright red light goes out!
when heli is fully charged bright light on computer end of cord comes back on......disconnect
heli right away.....if left on charge your battery could wear out....it takes about 50-60 minutes

I found your question while searching the web for parts for my son's new, broken Air Hawk II. I also found that there are a few different mini helis marketed as "Air Hawk", so I'm not sure that my answer will apply to your machine. Mine came in a box as shown here: http://www.toygalaxy.net/2chmirche.html

OUR problem, which might be your problem too, is that the cylindrical metal weights flew off the ends of the stabilizer bar at the top of the heli. First, one came off, which threw the heli out of balance, which caused a violent shaking that probably helped the other weight to fly off. Without the weights, the stabilizer can't do its job, and the heli sways. Our temporary fix was to cut two strips of duct tape, 3/4" x 1.5" each, and wrap one strip around the outer 3/4" of each end of the stabilizer bar. This made our heli fly almost as well as it did when brand new.

The heli pictured here is almost identical to ours, and has the same weights on the stabilizer bar - these photos show what our SB looked like before the weights flew off... http://www.dhgate.com/2ch-rc-helicopter-air-wolf-co-axle-rtf-palm/k-ff808081278edf340127988dde3b153d-0.html#todescription

Hope this helps... happy flying (we can wish, right?)

either stripped the main gear inside the heli or the main blades where they slide on the shaft. you should be able to buy a replacement set of blades. try that and see if it'll fly.

1.Take out charging wires. 2.turn off your heli and insert charging socket into your heli's socket. 3.the charging green light will light up while charging. 4.charging complete, the green light will turn off. 5.pull out the wires and you are ready to fly. Let the heli's battery cool down for approx. 15 minutes before charging.

hovoc heli doesn't what to fly more than two inches and than falls over,

You only need one frequency to be able to fly it. So it's working fine.