Question about Servis Dishwashers

Open Question

Servis dishwasher starts but after a minute number 1 light flashes,the bottom fills up and does drain ok but the water doesn't come out of the arms

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: beko dishwasher fills with water, does not wash but will drain the water away

impellor buggered. Needs replacing

Posted on Apr 12, 2008

Ad

SOURCE: Zanussi ZDT6252 stops 1min into cycle

You need to reset the computer on the bottom. Had the same problem with mine. The Blinking led means the heating element is bad and will not operate.

Posted on Jun 05, 2008

kachbibi1
  • 979 Answers

SOURCE: Hotpoint FDW60 Flashing lights 3 and 5

Is it possible that water has gotten inside the controls that could have caused the flashing lights? Kind of like spilling water on a calculator, everything seems to go haywire.

Posted on Jan 11, 2009

  • 1 Answer

SOURCE: frigidaire fdb949gf dishwasher won't spray water from arms

I found on my first dishwasher the arm holes were plugged. I had to clean out each and every hole with a small wire. They would not even turn until I cleaned them God luck.

Posted on Jan 31, 2009

  • 1 Answer

SOURCE: Kenmore dishwasher Lock On light flashing

holding the button for four seconds will not do it, you have to hold it until the light stops blinking and
will go back to normal, normall takes more than four seconds to unlock the unit, this is something
the sears repair techs know becouse the are trained on all this things but, they will not share this things, becouse thats how they make money

Posted on Apr 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Start light flashing,rince light on.machine will not start cycle


Hello. I really need the make/model number to help you accurately. However, from the symptoms you're describing, it sounds like the drain pump is jammed. A lot of dishwashers turn on the drain pump first to remove any stagnant water sitting in the bottom of the pump. Then, fresh water is let into the tub, fills to the proper amount, then the main pump starts. The lights flashing are an error code--different combinations of buttons flashing mean different things. On some models, a button light will flash a certain number of times, pause, then flash another number of times. This is a binary code telling the user what is malfunctioning. That's why I need the model number and any other info to help diagnose the issue. Thanks!

Sep 18, 2015 | Dishwashers

1 Answer

Dishwasher stops after filling with water


there is a problem with the drain. It is not draining all the water.
1. The drain hose could be too high.
2. There is a plugged pipe
3. There is debris in the drain hose or the pump

May 31, 2013 | Fisher and Paykel Dishwashers

1 Answer

Lcode 1 flashes and drain pump doesn't stop


The flash code means there is water in the base panel underneath appliance first check the support on your lower arm isn't loose then leave to dry out

Jan 01, 2013 | Hotpoint-Ariston LFT 321HX Dishwasher

1 Answer

F4 message on the top drawer, fisher paykel. I clean the filters and arm every week or two.


There 2 possibilities with this error:
1)
  • Fault with water fill (only on machines with level-controlled fill)
  • Note: Lights blinking, pump running and controls dead indicates an over fill fault
2)--4 Flashes--Draining failure. Drain pump, control board OWI or water indicator defect

God bless you
5_15_2012_4_40_23_pm.gif5_15_2012_4_40_44_pm.gif

May 14, 2012 | Fisher and Paykel 23 in. DD-603SS Built-in...

1 Answer

Whirlpool dishwasher wont wash


if the bottom tub is filling with water but not washing the issues is with the wash motor, some of this model use a start capacitor that can fail, if it has a capacitor on the side of the motor it may have failed but are difficult to diagnose but are cheap to replace so worth trying, if this doesn't help or if it doesn't have a capacitor then the fault is with the wash motor.

Mar 08, 2012 | Whirlpool Gold 24 in. Built-In Dishwasher...

1 Answer

Optima G2430 Miele dishwasher with intake/drain flashing light


Hi,
F13 is an inlet fault.
First the unit drains and then fills with water. When the unit has intially drained open the door and manually fill the unit with water, about 5lts. This will then allow the dishwasher to go to the next step which is to circulate the water. If this works ok then the water tap is defective, water inlet valve is defective or the electronic unit is not sending the signal to activate the valve. The water inlet valve is the white square box attached to the tap. Remove this and check the filter and make sure water comes out of the tap.If ok then remove the bottom panel of the unit under the door. On the right hand side there is a 2 core cable with a male and female connector. Unplug this and check for voltage from the electronic when the unit goes to fill with water. If there is 240v then the electronic is ok. You will then need a new waterproof system from Miele.

Feb 27, 2010 | Miele 24 in. Incognito G843SCVi Built-In...

1 Answer

Maytag Dishwasher Quiet Series 200


The 3 symbol on the face control panel light is on and starts flashing anytime you push any other button, and is full of water in the bottom of it. My wife says she stopped the washing cycle a couple of days ago but now it wont start back up.
This is a Maytag series 200

Mar 15, 2008 | Dishwashers

1 Answer

Zanussi ZDT6252 stops 1min into cycle


You need to reset the computer on the bottom. Had the same problem with mine. The Blinking led means the heating element is bad and will not operate.

Dec 30, 2007 | Zanussi 23 in. ZDT6252 Built-in Dishwasher

1 Answer

Asko 1585 Dishwasher


do they flash lik all on one side then the other? Start a cycle, then open the door. Do the lights flash the same way when you open the door as when it stops? if soyou may have a door that needs to be adjusted so it closes better. when the cycle ends, is there any standing water in the bottom? if so you may have a poorly routed drain hose or a partial clog in it. Last, pull the bottom panels off and look inside the bottom of the dishwasher and see if there is standing water down there . If ther is you have aleak somewhere or a bad drain pump. You r only other choice is a bad pressure switch. If youve already adjusted the water fil to the proper level ( just up to the grey plastic housing that the lower wash arm sits on) tehre really aernt any more options. Hope this helps!

Aug 29, 2007 | Asko 24 in. 1585 Built-in Dishwasher

1 Answer

Oh No


ANTI-FLOODING CONTROL SYSTEM ALARM [A L 4] Leds [LD9] + [LD10] This control system is operative during the washing phases only, and not in the water fill phases, in which case is it connected to the safety device (see paragraph 7.4.1 ?Water Fill Time-out?).  A float-actioned mechanical sensor positioned on the bottom of the appliance trips a microswitch which is connected in series to the fill solenoid, thus disconnecting the solenoid.  Intervention of the sensor is detected by the electronic control board, which actions the drain pump for 1 minute, after which an alarm condition is generated. Possible causes: a. Water leakage from the tub/sump seal b. Water leakage from the various couplings (motor, OR on the duct to the upper spray arm, etc.) c. Floating sensor jammed mechanically/microswitch faulty

Jul 14, 2007 | Zanussi 24 in. DE6744S Free-standing...

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Servis Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Eric Taylor

Level 3 Expert

559 Answers

Gil Davis

Level 2 Expert

156 Answers

Are you a Servis Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...