Seiki tv has horizontal lines, showing double and jumpy.

To reverse the picture on your SEIKI SE32HY10 TV, you can try the following steps:

1. Press the "Menu" button on your TV remote to access the main menu.
2. Use the arrow buttons on your remote to navigate to the "Picture" or "Display" menu.
3. Look for an option called "Picture Orientation," "Mirror," or "Flip Horizontal/Vertical."
4. Use the arrow buttons to select the option and press "Enter" or "OK" on your remote.
5. Check to see if the picture has been reversed. If not, try selecting a different option if available.

If you are unable to find the "Picture Orientation," "Mirror," or "Flip Horizontal/Vertical" option in the Picture or Display menu, it's possible that your TV may not have this feature. In this case, you may need to contact SEIKI customer support for further assistance.

sure taking very carefull your tv to repair shop
try not to touch the glass its very sensitive if you broke its the end

Your picture tube is about to go.
If it's still under warranty,take it back.
Hope this helps.

I also have a 35" JVC that just started doing the same thing. Did anyone post a fix?

vertical output ic needs to be resoldered. careful leaving that bright line displayed on the screen as this will cause a permanent phosphor burn into the tube. this can not be corrected once burned unless you replace the tube. mch

Your problem is capacitors CP204 and CP205 by the 9 volt regulator on the main board. Cp204 is a 47 microfard @ 50 volt and the other is 100 microfard@ 16 volts

Its definately fixable. Can you post a picture of what your refering to when you say horizontal lines and jumping? Also do you have any soldering ability or troubleshooting experience? Let me know

Yes . Some of these caps are in the secondary of the power supply and some are on the signal board around 5v and 7v supply lines on the signal board . The 5 & 7 are mounted on heat sinks and the caps are right around there .Generally either 2.2uf or 4.7uf or the 47uf . Good luck