Question about Garden

3 Answers

I have a 1995 John deer sabre. It won't start unless I jump It. I've changed the silinoid, bypassed the seat safety switch and the clutch. Everything has juice. What's my next step?

Posted by on

  • 1 more comment 
  •  johnny rebel
    johnny rebel Apr 18, 2015

    ok,think i found it,it is a sensor by your ign switch,it is a battery discharge sensor,it is number 14 on this diagram,part number AM125252 Sensor | BATTERY DISCHARGE,i will also give you links to see more.

  •  johnny rebel
    johnny rebel Apr 18, 2015

    http://www.circletractor.com/OemParts?_B...

  •  johnny rebel
    johnny rebel Apr 18, 2015

    http://www.searspartsdirect.com/sabre-jo...

×

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Master
  • 10,875 Answers

I have a 1995 John deer sabre. It won't start unle - 1995-john-deer-sabre-start-unless-jump-s2334v25gcrexvzx51b1irkp-5-0.png

Posted on Apr 18, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,128 Answers

You're saying that it will start if you use a booster battery (jump start)? If it starts and runs but then needs a jump again next time you want to use it, then you have either a bad battery or a bad charging system.

Posted on Apr 14, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,169 Answers

Normally seat switch provides nothing but an ignition kill circuit.

Depending if you have a solenoid the has 2 small wires or 1 It can be loss of ground. Basically is there voltage at solenoid trigger connection? if so is there voltage at the start terminal on ignition switch? If not is there voltage at battery terminal of the ignition switch? If not you probably have a blown fuse.

Posted on Apr 14, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pic498
  • 32 Answers

SOURCE: 1987 john deere 750 compact tractor 4 wheel drive, wont start

percussive maintenance my friend. Try banging on the solenoid and starter with a hammer while in the start position. Also, if you have a voltmeter, you can see where voltage is getting to and that will help you as well.

Posted on Jun 13, 2009

  • 133 Answers

SOURCE: John Deere Sabre 14.5/38 HYDR lawn tractorWont't

See if there is a plastic connector on the wires leading to the seat switch. If there is try disconnecting it and use a piece of wire (with insulation on it) to use a jumper. There is probably two wires coming from the tractor to the seat. After disconnecting Place one end of wire into the wire connector coming tractor and the other end of wire in the same connector on the other side. That will act like the seat switch is closed like you are setting on it. Try and start. Had the same problem on an electric hyster at work and that was the fix we used because the switch is pretty expensive and a hassle to change.
Hope this helps

roundo4

Posted on Aug 04, 2009

mickey813
  • 472 Answers

SOURCE: John Deere L120. Engine dies when PTO switch is pulled.

sounds like the seat switch is bad

Posted on Mar 02, 2010

wireguy212
  • 1627 Answers

SOURCE: John Deere L120. When the mower clutch is engaged

Try a new seat switch,or the rio switch on the right rear of the trans-axle.

Posted on May 17, 2010

wireguy212
  • 1627 Answers

SOURCE: problem with John Deere L120 tractor

Park brake switch is the most likely culprit,any other would cause the tractor to not turn over in the crank position.

Posted on Jul 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

John Deere L110 riding mower automatic won't start


have you checked the micro switch under the seat

May 31, 2013 | Garden

1 Answer

I have a john deere LT 150 that will not start. When you turn the key nothing happens. I've checked the seat switch , the mower engage switch and a new brake/clutch switch. Battery is good. You ca


you have a safty switch problem you have 4 to 6 switchs the easest way to test them ,startin with the seat get a ohms metter they are open or noramly closed

Oct 23, 2012 | John Deere Garden

1 Answer

Have a john deere sabre turn key won't start thought battery was dead charged battery still won't start jump start with car battery it will start then . try to engage reverse with blades running it...


Some mowers have a mowing reverse safety switch. That safety will kill the mower if you try to reverse with the deck engaged. Some mowers even have an override button that has to be held while backing up. As for the battery thing, no matter how much you charge a bad battery you will not get it to start a mower if it has a bad cell or two. I would use a multimeter to check battery voltage, but the end result would still be the same, replace the battery.

I hope this gets you going again.

Aug 07, 2011 | John Deere 22HP VTwin 48" Riding Mower

Not finding what you are looking for?
Garden Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2478 Answers

john h

Level 3 Expert

12104 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...