Question about Garden

1 Answer

Why does my lawnmower start and then shut down immediately?

Starts no problem then immediately stops?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Master
  • 1,727 Answers

Sounds like the carb needs to be cleaned but you should of included the type of engine. then I might of been able to direct you closer to your problem

Posted on Apr 14, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my car shut down while driving?


There might be a problem with the alternator, specifically the diode trio that is inside the alternator. Have your charging system checked. You can do it yourself if you have a voltmeter. Start car and check voltage across the battery terminals. You should get 14.5 volts or higher.

Sep 24, 2015 | Cars & Trucks

2 Answers

Why does engine stop when clutch released or blades engaged?


Make sure have a good battery when you start the blades on any lawnmower it need lots of power to get it going

Jul 17, 2014 | Murray Garden

1 Answer

Lawnmower wont start after running then stopped for short period


It should be. The fuel line is under the tank and runs to the carburetor. Make sure you use the fuel shut off, if you have one, or drain gas before you play with the line. Once you find the line disconnect it from the carb and drain any remaining fuel. Then clean with a pipe cleaner and reattach. That should help.

Apr 17, 2013 | Craftsman 190cc 22" Rear Drive...

1 Answer

My computer continues to shut-down for no apparent reason while booting up. It will get to bios then abruptly shutdown. Please Help!!


Maybe something is defective from the factory? Can you bring it back and exchange it for another? Is it a desktop or a laptop? If it's a desktop, maybe remove a side panel and aim a small fan at the inside. Do you know how to start up your computer in safe mode? Maybe try starting it in safe mode and see if you can do a system restore, do you know what that is and how to do it? Google will explain it to you, but I'd suggest those steps.

Mar 21, 2017 | Gateway Fx Computers & Internet

1 Answer

My 1999 Chevy Lumina shuts down while driving and will not start immediately. It may start after a while but will shut down again. When parked, it starts and idles for a while and may or may not shut, but...


it sounds like your ignition module is failing, when the car dies, take off one spark plug wire from the coil and crank the key, see if there is spark. one other issue may be the crank position sensor which can also stop the module from firing a spark

Sep 25, 2011 | 1999 Chevrolet Lumina

1 Answer

Brand new honda lawnmower starts and runs fine then backfires


There should be 1 or 2 screws on the carb. You will probably have to remove the air breather to get to the screw(s). I've been seeing a lot of these types of questions, new equipment not running properly. Factory settings were not set properly.

When you find the screw(s), screw in a clockwise direction until it stops; DON'T SCREW DOWN TIGHT, JUST UNTIL IT STOPS. Then unscrew counter clockwise 1 1/4 turns. Try starting.

Continue this process, 1/4 turn at a time up to 2 1/2 full turns. If you forget where you are at on the turning process, start over by screwing back down. Then pick up process where you left off.

If you need further assistance, just let me know.

Jim

Jun 21, 2009 | Craftsman Garden

1 Answer

Wont stay running without pushing primer


Hi... I have a Poulan PRO Quantum xnp 6.75. Garage kept, unused approximately 2 yrs. Added fuel, primed & mower started but then shut down immediately. Then fuel began leaking from the primer button. I'm a single mom & CANNOT afford to have anyone fix this. However I am attempting to repair myself. PLEASE.... If you have any suggestions &/or solutions I would LOVE to know.

Apr 12, 2009 | Garden

Not finding what you are looking for?
Garden Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2478 Answers

john h

Level 3 Expert

12104 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...