Fill light and door locked lights flashing after brief power outage. What next?

It seems like your washing machine is experiencing a common issue after a power outage. This could be due to a disruption in the machine's cycle. To resolve this, try the following steps:

1. Reset the Machine:
   • Turn off the washing machine and unplug it from the power source.
   • Wait for a few minutes (around 5-10 minutes).
   • Plug the machine back in and turn it on.
2. Check Door Lock:
   • Ensure that the door is securely closed and the lock is engaged.
3. Restart the Cycle:
   • Select the desired wash cycle and press the start button.

If the issue persists, it might be helpful to consult your machine's manual for specific troubleshooting steps. Additionally, power fluctuations during the outage might have affected the machine's electronics. If the problem continues, consider contacting the manufacturer's customer support for further assistance.
Remember, power interruptions can sometimes cause electronic appliances to behave unexpectedly, and a simple reset often resolves such issues.

FIXED Kenmore dishwasher lights flashing: "Hi Temp" & "Heat Dry ...

www.applianceblog.com/.../40588-Kenmore-dishwasher-lights-flashing-...

Aug 26, 2013 - 10 posts - ‎3 authors
Thread: Kenmore dishwasher lights flashing: "Hi Temp" & "Heat Dry" ... A few months ago, we had a brief power outage and the next morning, noticed the "Hi Temp" and "Heat Dry" lights were flashing. ... Well since then, the dishwasher intermittently stops mid-cycle and these same lights ... Thread: GE Eterna QuietPower 2 Normal and Heated Dry ...
6 posts
Feb 24, 2012
Kenmore Elist 665 dishwasher Smart Wash red light ...
6 posts
Dec 23, 2011
Heated dry blinking +17 times - ApplianceBlog
10 posts
Nov 14, 2010
Heated Dry light blinking
3 posts
Nov 7, 2010
More results from www.applianceblog.com

Why won't my dishwasher start and why does the "Heated Dry"

www.shopyourway.com > Manage My Life > Questions

Nov 16, 2009 - When I hold down the Heated Dry button to turn the control lock on it ...my dishwasher start and why does the "Heated Dry" light keep blinking ...

This is not a sensor issue, I have a similar problem, sensors work fine, garage door is still fully functional, all operations, including safety sensors work properly, just the overhead lights flash. I suspect there was damage to the power board due to a power surge, going to order a replacement to see if it works, will let you know how it goes.

BUY A NEW ONE

I would first of all unplug the opener for at least 15 minutes and see if it doesn't reset. If not, pull the logic board and check for burnt or missing traces on the printed circuit board.

Try holding down on the power button until the leds stay on ... then release it. Don't just tap or push the power button once.

If the door does not lock at this point it probably needs door lock replacing

Actually it sounds like the vacation lock has been enabled. To turn it off press and hold the lock button for 2 seconds and test it out. If this is not it then you will need to replace the logic board and get a surge protector as well. Thanks BB

"PF" indicates the electronic control detected a Power Failure.
This could have been caused a brief power outage OR may be an indication that the connections to the oven, either at the stove or at the plug are loose.

Unplug the machine for 4 hours & then plug back in. If you get the same symptoms, it will be cheaper to replace with a new one. Power supply is probably blown.