It just makes a noise and won't shoot - Senco FN65DA F-15 15 GA Fusion Finish Nailer

It is a toy that has 2 plastic bottles and 2 plastic cans and an infrared gun. You set the cans and bottles on the buttons that are pushed down and shoot with toy infrared gun and they pop up and shoot the cans and bottles off

Try unplugging it for 30 seconds and see if it resets. If not, take the model # and get on the internet for the manual and go to trouble shooting page. It should answer your questions

I'm sorry but you need to proof read your comment. From what I see is that your fuel system is at fault. Have you ever replaced your fuel filter? How many miles does it have on it?

the sounds are run off of a different battery source, check the battery under the seat and make sure that its connected

Hi
Make sure the water taps are turned on. The humming sound is most likely from your inlet solenoids.

Check both the hot and cold water inlet hoses going to the back of your machine. Make sure they are connected properly and that the water is turned on.

If still no joy let me know and I will guide you through more trouble shooting items.
Ash

Hi,

Many times a freezer and/or refrigeratordo not work right because of a dirty condenser coil...there are also many otherthings that can go wrong. If you are hearing a clicking or buzzing thencheck out the last two tips.

If your refrigerator is running but warm, then...

Check out these tips that I wrote about that... it is a great place to starttrouble shooting your unit...and something that you can do rather then callinga repair person to do a simple thing for you...

Refrigerator Condenser Coil Cleaning Refrigerator Repair

Refrigerator Troubleshooting Refrigerator Compressor

Refrigerator Compressor Start Capacitor and Start Relay
Refrigerator or Freezer not Cooling or Getting Cold

heatman101

;;'

Hi your unit has lens unit defectiveness. It won't reset itself initializing. The noise come from initializing IS unit defect. your local repair shop would charge around $45 to 115 depend on what they really want to charge. thanks and best regard!

check the actual door switch,, you can jumper it to see if this is the problem, Just connect the 2 wires together , if this cures the problem replace the switch

Zooming in too far will make your photo appear fuzzy if your camera has Digital Zoom.
For more info on Digital Zoom: http://en.wikipedia.org/wiki/Digital_zoom

Also low levels of light may degrade the quality of the image(depending on your settings)