Registration Model #on box instructions, and bill and they keep saying it is not correct.SV75Z_N14 The model # is on everything and it keeps telling me it is not correct.

What is the brand and model of your vacuum cleaner? You can usually buy instruction books for most brands here: http://evacuumstore.com/p-2819-eureka-instruction-book.aspx I know it says Eureka instruction book but if you call 1-866-972-8227 to order and give them the brand and model of your vacuum, they'll send you out the correct book.

here is the site.


http://www.ninjakitchen.com/cgi-bin/livew/site.w?location=b2c/product-registration.w&frames=no&target=main&sponsor=000007


Good luck and Thanks

Your battery could be weakening. The batteries to these Roombas seem to only last about a year, before getting weak. It is recommended that you keep your Roomba in use a lot and also recharge it often to help the battery last longer. Seems strange to me, but that's what it says in the instructions. I haven't had mine very long yet, but I'm trying to follow what they say to keep my battery running longer than one year. Go to the website where they have an assortment of batteries available for you. Just be sure to get the correct one for your model.
Good Luck.

For most clocks of the RCA clocks without a clock or time set button, press Set until you see the clock icon. Press the fwd or rev button to change the time. Release the button when you reach the correct time. (AM or PM will be indicated next to the time.)

There are manuals for several RCA cd clock radios available from their site: http://support.rcaaudiovideo.com/select.aspx?u=manual . Check if your specific model is listed in the menus.

I hope this helps.

Cindy Wells

in your browser type in make and model/manual to find the imfo you need

hi, I have a few questions:
1- Your question is listed as a "Vacuums Problem". is that correct?

2- Your writing is broken-up, I think that you have a problem with a sewing machine. is that correct?
If correct, can you tell me that brand, and model of it?

3- What exactly you are trying to do?

Hello,

Here's a link to a video instruction manual that shows how to but on the Kirby Shampoo attachment on the newer Kirby Sentria model, however the instructions are exactly the same for attaching the shampooer attachment to your model.

How to Attach The Kirby Generation Carpet Shampooer Equipment

I hope that this helped you get the shampooer on your Kirby! If not, please feel free to use the comment box on this page to ask me any follow up questions that you may have. I'm always more then happy to answer any follow up questions.

If this was helpful, please be so kind and rate my repair, or leave feedback for me. This is greatly appreciated by the Fixya community when a solution answers a problem, and is really what keeps the community answering free questions, rather then just ones that are premium or paid questions.

Thanks so much,

Chris Jones
GoVacuum.com

Hi,
Yes there should be a filter fitted onto the top section.

For suppliers, it would be cheapest to find your nearest stockist, or buy online and have it shipped. It's still current stock - so spares should be readily available.

Sears stock it -
CRAFTSMAN FILTER

Thank you for using Fixya,

Make sure you take off the little cap at the end (the one that spins -- just grab it and pull it straight off) and clean under it too. The rest of the brush may look perfectly clean but what happens is that hair gets stuck under spinning cap and, like a slowly growing washer, it pushes the whole brush toward the gear box. When it gets pushed over enough, the large yellow ring starts to rub against the side of the brush deck making it harder for the motor to turn the brush and you get that "remove and clean brushes" message.