Phone saying no link to base - Lands Phones

Hand each phone up on the base and it will marry it. If you continue to have no link to base make sure everything is plugged in correctly. If it persists you probably have a defective phone.

Try unplugging the base unit and plugging it back in again. This is not guaranteed to help but has worked in the past.

several things check the base is connected to mains power and switched on.
You have obviously checked to see if it is outof range,and checked the batteries.
If you are using more than one base check that you ar connected to the right one.
Also if you have too many appliances connected to the phone point they won`t run.

The handset has lost the link with the base. This link codes the handset to the base with a unique security code so others with the same phone cannot use your phone line.

If you changed the battery, try disconnecting the base telephone line and ac adapter for a while (1/2 hour or so if possible).

Remove the battery from the handset as well.

After 1/2 hour, install the battery in the handset, connect the telephone line and ac adapter to the base. Place the handset in the charging base and the link should be established. If not, the phone is defective.

[email protected]

Hi,
Switch the mains off 5 mins,
Re-register the phone to the base.
Should be good then

Regards
Richard.

HI NEED HELP MY PHONE IS SAY NO LINK TO BASE

I also have no link to base message but only on one of my two handsets. One works the other doesn't.

Any suggestions?

put the phone in its base and then un unplug the phone for 5 seconds plug it back in and check for a dial tone.

to re-register the phone, hold down the "handset locator" button on the base untill he "charge" light flashes. then, on the phone, hold down the flash/call waiting button until the LCD screen says "handset registering." if after it registers it says "error!!!" then retry. that is what it says in the instructional booklet, but i have not done this successfully. mine keeps saying error.