Question about Durabrand DWT2405 24" TV

1 Answer

Durabrand Television My TV is about 2 years old. And when I press the power button the red power light comes on but the TV itself doesn't turn on. I unplug the TV for about 15-20 minutes, and then plug it back in. Then it works, for about 25-45 minutes (approx.) and then it turns off by itself. What is the problem??

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers
Re: Durabrand Television

Cold sorters that means needs to sorter it again

Posted on Dec 12, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Dish tv remote code

Hi L. Pruett, my name is Mike Houston of DISH Network and withthe Durabrand TV there are a couple of codes we do have for that TV. The threedigit codes will be 220 and 233 and what you will want to do is hold down the clearTV button until all the mode buttons light up. Press one of the three digitcodes I have sent press the # button and then press the Red TV button on theremote, the TV should have turned off and if not after trying the two 3 digitcodes I will send you a link for a Power Scan; Mike H.

Nov 14, 2011 | Durabrand DU1901 TV

2 Answers

Sony Trinitron color TV 36 inch


You should examine the input power of the TV. If you dare to open the back of the TV You should examine the by using the tester to test the continuity of the voltage input of the TV. i guess voltage regulator need to be tested.

Be careful high voltage inside the TV.

The best way is to contact the vendor of the TV or sony service center in your area.

may this help,


May 12, 2008 | Sony FD Trinitron WEGA KV-36HS510 36" TV

1 Answer


Hello You just buy one Philips CL 034 model Universal remote control, which can be programmed with your Duraband TV. The porgramme codes are
0520 0115 0317 0916 0027 0447 0323
Direct Code Entry 1. Press and hold the CODE SEARCH button until the red indicator stays on, then release the CODE SEARCH button. 2. Press and release the desired Mode button (TV, VCR, etc.). The red indicator blinks, then stays lit. 3. Enter the 4 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashes. 4. With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your device, try one othe other codes for your brand. Ok

Nov 27, 2010 | Durabrand DWT2405 24" TV

1 Answer

I have an RCA television. After watching it on Friday, and turning it off. When I went to turn it on Saturday I had no sound or picture. The on/off button lights up when pressed. You can hear the TV click...

If tv is a few years old could be power supply capacitors faulty, sometimes the tv could come on after a while , had this problem on friends tv, Only cure would be replace capacitors, not a job for novice though.

Nov 08, 2010 | RCA Standard (CRT) Televisions

2 Answers

Remote code

Hi trckynky,

I am unable to find the Duraband tv, however many times you can search fo one that will work.

Try this.
  1. Turn on TV
  2. Press and hold the TV button on the remote
  3. While holding the TV button also press and hold the power button.
  4. The light on the remote should go out and then a second later come back on.
  5. Release both buttons, the light should remain on.
  6. Aim the remote at TV and press the power button about every 5 seconds until TV turns off.
  7. Press the STOP button at bottom of remote., this will lock in the code.
  8. Use the remote to turn TV back on and test all buttons on remote to insure you have the correct code.
If the remote will work with Durabrand this is the way to find it, unfortunately the remote may not work for all TV's.

Let me know if I can assist further.

Please rate this solution.


Apr 23, 2009 | Durabrand DWT1905 TV

1 Answer

Tv wont turn on, red flashing light


Apr 11, 2009 | RCA 32V524T TV

1 Answer

TV keeps turning itself on and off, onto standby

I managed to find a local repair man who fixed the problem. He put in a new transformer.

Dec 01, 2008 | JVC AV-32D305 32" TV

2 Answers

Durabrand TV picture died. 2 yrs old

hats the shelf life on that tv

Jan 21, 2008 | Durabrand DWT1905 TV

1 Answer

My television won't come out of stand by

Basically it sounds like you have no power otherwise because I am assuming you have also tried the power button on the TV itself. Does the light on the TV do anything at all when the power button is pressed?

Feb 06, 2007 | Sharp 32F-830 32" TV

2 Answers

TV won't turn on

The red light instead of green is an indication that theres a voltage missing or an improper voltage in the sweep or main power supplys. This should be handled by a trained service tech. Good Luck

May 28, 2006 | Durabrand DWT2704 TV

Not finding what you are looking for?
Durabrand DWT2405 24" TV Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Durabrand Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66587 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Durabrand Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides