No power to fisher paykel washer. Replaced pump

Fisher and Paykel GWL11 Top Loading Washer

ths.gardenweb.com > Home Forums > Laundry Room

Mar 5, 2008 - My GWL11 Top loading washer has had nothing but problems! ... 4) (Rinse Phase) Drain the water, then lock the lid for spin. ..... I plug the power cord in and I have nothing on the control panel. ..... As the controller was only replaced early in January, I've flicked F&P NZ an email to see if it's still under ...

How to repair a Fisher Paykel Washing Machine

www.instructables.com/.../How-to-repair-a-Fisher-Paykel-W...

InstructablesI removed the pump and control panel, found no blockage in the pump, so far ... Ihave just tried to fill my F/P machine but the water is just dripping in. ... I have aFisher Paykel washer have replaced the control module and now it .... washing machine MW612, stopped working and displayed beeping sound every second.

please visit link below for more information on your error code.




http://www.searspartsdirect.com/washer-repair/error-codes/fisher-paykel-aquasmart-top-load-washer-error-codes.html




Fisher Paykel AquaSmart Top Load Washer Error Codes Sears PartsDirect

http://ww2.justanswer.com/uploads/thehomesmithy/2010-12-19_141627_gwl11_iwl12_iwl15_suppliment_togwl03_manual_.pdf


here is the manual
it has detailed info on your error code
96 decimal is 01100000 binary

so look for that.. youll see what i mean when you look at the manual
i think its a phase 6 error
and looks like something to do with the pump

Read page 4 of this

http://www.rakerappliancerepair.com/NephewClub/Diagnostics/Washers/Fisher_Paykel/F-P%20-%20Bulletins%20-%204-08.pdf

check drain pump is not blocked or faulty

This is a pump stall error code. Remove the pump from bottom of washer. make sure nothing is clogging pump. If problem persists replace pump.

Check the ohms reading on the pump.
If less than 32 ohms(240v) replace pump.

62. (00111110) Phase 5 - Pump Over Current
The Motor Controller module has detected an excessive pump current.
Primary Source: Pump.
Action:
Replace Pump.
Secondary Source: Motor Controller module.
Action:
Replace Motor Controller module.
107. (01101011) Phase 2 to 6 - Motor Controller module Reset Error
The Display Module has detected that the Motor Controller module has reset when
it should not have. This can be due to a Motor Controller module supply
disturbance or microprocessor failure.
Primary source: Motor Controller module.
Action: Replace Motor Controller module.

Red, Blue, Yellow go on the motor
Brown , White go on the pump.

faulty pcb Regards Advisor