How to tub clean my american home awf-63g model

A few possible causes:

Blocked Water Level Switch: Most top-loading washing machines utilize a pressure switch to tell the water when to shut off during a wash or rinse cycle. If the tube becomes blocked with minerals from hard water or if the switch itself goes bad, the water will never shut off.

Bad Water Valve: Valves at the points where the hot and cold water hoses enter your washing machine control the flow of water into the machine. If these valves become stuck open, or if their seals become lost or compromised, the water will continue to flow into the machine.

Faulty Controls: The controls might fail to acknowledge the input from the pressure switch and never advance from one cycle to another. In some cases, this is a voltage problem, while in other cases the controls themselves are bad and would need to be replaced.

If you've already cleaned and cut the ends of the tube going to the level sensor and the issue persists, it might be best to consult with a professional appliance repair service. They can help diagnose and fix the problem accurately. Please remember to turn off the water supply and unplug the machine before attempting any repairs.

call a local repair service

cannot spin my washing it always go back to rinse

contact the machine manufacturer's customer support and you can ask them what error E5 is you could also ask for new manual and that might have error codes in it , make sure you have serial number and 12 digit number .

to drain the tub ,just put the drain hose lower than the tub
as for the rest have a technician check the program board

Good Morning Friend,

I understand that you want to know where the drain pump is located on your Electrolux washer, model# AWF 1435. In researching the model number you provided, I show that this was manufactured in France. I suggest contacting the manufacturer directly, for further assistance. They should be able to tell you where the drain pump is located in your appliance. Hope this is helpful.

-Best Regards-
WP

Yes , the machine can be converted to manual operation but will require a set of timers , switches and wiring so that the independent cycles of the program are controlled by these manual modes.
You will need to wire the motor to a timer, the input and drain to switches. All these functions protected by bypassing the door switch which will reset power only when door is closed.

The model number on Kenmore top loaders is usually printed on a nameplate along the wash tub rim opening under the washer lid. The model number has 8 digits with a prefix of "110". If you cannot locate it, please let me know. I hope this helps you.