Question about Acer Aspire 3000 Notebook

1 Answer

Satellitte A55-s1066 no power, the charging led light is blinking and sometimes blinks one and follow the battery led light blinks ambar too

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers
Re: satellitte A55-s1066

Suspect defective mainboard.if its still under warranty send it to repair depo.

Posted on Nov 24, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Flashing yellow light

attery power LED off, and Caps Lock/Num Lock off Battery or AC Adapter AC adapter not connected or failure

Battery low charge or failure Battery power LED blinking Battery Insufficient charge on the battery c02983514.gif When new computer is used for first time, the white LED light for the AC power connector blinks. Battery is still in "Shipping Mode", the light continues to blink even when AC power is connected.

To resolve, turn off notebook, connect AC power and allow battery to charge for at least 30 minutes, then start computer.

Dec 20, 2013 | HP Pavilion ze4300 Notebook


Laptop LED Blink on Startup There are many reasons that a computer does not...

Laptop LED Blink on Startup
There are many reasons that a computer does not startup or boot into the Windows operating system. If your computer will not start or boot, you will see or hear symptom to indicate the general area of the problem.
Startup Symptom: LEDs blink but does not start
The blinking LED lights on newer computers, or the beep tones on older computers, will help support agent determine what hardware component is not responding properly. The exact meaning of each code varies with the model, and the user cannot change any of the blink or beep codes.
DO THESE FIRST - Perform a hard reset.
If a PC suddenly fails to boot properly, you should perform a hard reset as the first procedure.
1. Disconnect all peripheral devices and remove all USB devices and media cards. You want to test the computer not the accessories!
2. Disconnect the AC power adapter, remove the battery and then press and hold the power button for at least 15 seconds.
3. Reconnect the AC power adapter (but do not connect the battery), Press the Power button, Look for glowing LEDs near caps lock and num lock keys, and Listen for sounds of a disk drive and fan turning.
Identify the number of blinks or beeps
When there is a start-up problem and you see LED lights on the keyboard blink a few times (between 1 and 8 blinks) do the following actions.
Table of Sample Blink Codes
The following table illustrates the meaning of blink codes used on some notebooks. The blink or beep codes on your computer may have different meanings.
Meaning of Sample Blink Codes for some EFI Notebooks:
1) Number of Blink: Continuous Glow, Blinking LED: Battery power LED, Component: Battery,
Error Condition: The AC adapter is attached and the battery is charging, but does not yet have sufficient charge to power the notebook.
2) Number of Blink: 1, Blinking LED: Caps Lock/Num Lock, Component: CPU,
Error Condition: CPU not functional
3) Number of Blink: 2, Blinking LED: Caps Lock/Num Lock, Component: BIOS,
Error Condition: BIOS corruption failure
4) Number of Blink: 3, Blinking LED: Caps Lock/Num Lock, Component: Memory,
Error Condition: Module error not functional
5) Number of Blink: 4, Blinking LED: Caps Lock/Num Lock, Component: Graphics,
Error Condition: Graphics controller not functional.
6) Number of Blink: 5, Blinking LED: Caps Lock/Num Lock, Component: system board,
Error Condition: General system board failure.
7) Number of Blink: 6, Blinking LED: Caps Lock/Num Lock, Component: BIOS,
Error Condition: BIOS authentication failure.
8) Number of Blink: Continuous blink, Blinking LED: AC power adapter LED, Component: Power adapter,
Error Condition: Insufficient power
Common solutions for issues that cause blinking LEDs or beep tones
When the computer can boot into the BIOS, run the memory test to identify other issues.
Check for loose connections and test the memory
Blink codes are often displayed after a user adds memory to the computer but does not seat the module properly. The LEDs may also blink error codes if a hardware component is loose because the computer was dropped or jarred. The problem could be that the stick of memory or one of the memory slots has a bad connection.
Check for loose memory modules
If a memory module is loose or is not making good contact with the memory slots, the computer does not recognize all of the memory. Reseating the memory module may resolve memory failure errors.

on Mar 21, 2011 | PC Laptops

1 Answer

The power led blinks and it wont turn on

charge the laptop only till it is required// excess of charging not only reduces the life of the battery but this kind of problem can rise.. now since the light is blinking do the following steps// take out the battery and hold the pwr button for one min// static elec will flow out and then put the battery inside the laptop and check// it should work normally..// if not then contact the manufacturer for repair..

Jul 06, 2010 | HP PC Laptops

1 Answer

Toshiba Satellite A55-s1066 need help Loacting Bios Chip.

you need to remove all at same time and memory modules too, and after remove the cmos battery, try to find a passw clear switch on the motherboard nearby cmos battery.

Feb 14, 2010 | Toshiba Satellite A55-S1066 Notebook

2 Answers

0190 critical low battery error

lights ambar blinking 5 times, stop, and again..
I was pushing the power button at the same time with thinkpad button, and fast press F1 key.
I only needed 3 times and it fixed problem.
Right now laptop remaining in bios mode, charging battery normally.
good luck!

Nov 24, 2009 | IBM ThinkPad T20 2647 Notebook

2 Answers

No Power Toshiba A55-S1063

sounds like the powersupply might be bad try another one if that dont help then your board is bad -sorry

Jun 29, 2009 | Toshiba Satellite A55-S306 Notebook

1 Answer

Power but not pic


Fn+F3 is the hotkey for Standby. However you can use Fn+F5 to toggle the display. If Issue persists disconnect the AC adapter and take the battery out then press and hold the power button about 5 seconds. Put back the AC adapter and battery. Turn on the computer. If you need further assistance please post your question.

Good Luck

Feb 17, 2008 | Toshiba Satellite A55-S1066 Notebook

1 Answer

Toshiba Satellite A55-s1066 wont boot

Check out this Toshiba document - Look about half way down the document to the section that starts with: * If the AC power light is blinking, try the following steps:... See if any of those suggestions help.

Sep 17, 2007 | Toshiba Satellite A55-S1066 Notebook

1 Answer

Oshiba Satellite A55-106

Can be because power supply is not correct supply or give incorrect supply voltage causing battery to drain or not charge fully,battery can be caput aswell, some laptops doesn't start if battery isn't conditioned properly. JJ

Sep 15, 2007 | Toshiba Satellite Pro 6000 Notebook

Not finding what you are looking for?
Acer Aspire 3000 Notebook Logo

Related Topics:

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acer PC Laptops Experts


Level 3 Expert

18259 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Henk de Ruiter
Henk de Ruiter

Level 2 Expert

78 Answers

Are you an Acer PC Laptop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides