What are the torque specs on 6.5 horse briggs and stratton engine . model no. 12s432 2137 for the head ?

Torque setting briggs stratton model 13A8693F190

Fixya https://www.fixya.com > Forum > Garden > Briggs
7 days ago - Need head bolt torque for Brigges Stratton 18 Hp ... 210 to 230 inch pounds. Torque in a crisscross pattern upper left lower right upper right or left or right.

Torque for briggs and stratton 6.5 mower engine
1 answer
Aug 15, 2019
I'm trying to find torque specs for the head on a - Briggs
1 answer
May 6, 2022
I need the engine torque specs for a Briggs and
1 answer
May 30, 2009
What are head bolt torque specs. for briggs and
1 answer
Aug 20, 2008
More results from www.fixya.com

How do I Find my engine specifications?

Briggs & Stratton https://www.briggsandstratton.com > faqs > browse > e...
To find basic small engine specs like torque, fuel & oil type, filter or cylinder info, check out specific product pages for your snow blower, lawn mower ...

and also

https://www.google.com/search?q=briggs+%26+stratton+13a8693f190+service+manual

..

whats the model number? for they have different torque

Doug, Torquing multiple bolts, like on a cylinder head are shown in last video link.Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
http://www4.briggsandstratton.com/miscpdfs/RNT/Engine%20Specifications%20Chart_ms3992.pdf
FAQ Small Engine Specifications Briggs Stratton Specs
Engine mounting pattern
HOW TO LOOK UP AND TORQUE BRIGGS HEAD
How to replace Briggs Stratton Intek Head Gasket Pt 2

not nearly as critical as you think. I bet 40 ft lbs on all bolts would be fine. It's more the consistency among the Bolts than the actual torque

Need model and type numbers.

if there is thread locking compound on bolt or threads it must be removed, use a tap to clean the threads and a wire brush to clean the bolts. Use a thread locking compound (blue) when reassembling, torque the bolts to 30 ft. lbs. alternating bolt to bolt in 7-10 lb. increments. Recheck the torque after the engine has been ran up to op temp.

Try sears Parts Direct .com if they cannot try PartsTreeReairClnic

WHAT IS THE VALVE CLEARANCE ON A 23 HP. BRIGS MOTOR AND THE TORQUE ON THE HEAD BOLTS?

Ring problems will do this

Anywhere from 35 lbs to 220 lbs, depending on the series of your engine. For your engine, the head bolt torque should be 190 lbs.

But I've attached a chart for you to utilize to make sure of your exact engine model series, just in case there was a transposed number, etc.

http://www.small-engines.com/torque.html

Here's the official Briggs & Stratton chart for all versions of their engines, which confirms the 190 lbs torque spec.

http://www4.briggsandstratton.com/miscpdfs/RNT/Engine%20Specifications%20Chart_ms3992.pdf

Hope you found this Very Helpful and best regards!