My washer constantly sounds unbalanced - GE 3.5 cu. ft. King Size Capacity Top Load Washer w/PerfecTemp System

frame brace / bushing damaged -not properly balanced

This sounds like a problem with an unbalanced washer or unbalanced load. Your washer has four leveling rubber screws underneath. To keep it from rocking make sure all four points are touching the floor at all times. Washer machine being level is a great plus. Also it could be the amount of clothes put into the washer. The more clothes you put in the less chance of your load being uneven.

sounds like a spring broke or fell off.

Please review the site below. I am sure it will assist you with you issues.

Please leave me a positve comment if this helped you...Thanks!...Jim

http://www.appliance-repair-it.com/clothes-washer-repair.html

sounds like washer is load sensing either overloaded or unbalanced when it decides to low spin insteasd of high spin dose it stop for second rotate 3 times and change direction 3 times the just spin slow.... if so either u have misloaded the machine by overloading orthe clothes are unbalanced in load may need add a towel or something to balance the weight evenly in the tub

first try your filter if there is one then check your pump

YOu more than likely have suds in your washer, or an extremely unbalanced load. push the pause cancel button twice, that should unlock the washer. open the washer, and look inside. Is there a lot of suds, or towels that are tangled up? If so, add some fabric softener to the wash tub and do a rinse drain spin (for suds) for the extremely unbalanced load, take the towels (or what ever load you are doing) and put about 1/2 of them in. I have the same washer and have experienced this "problem" once or twice in 7 years. And those were the two culprits. Hope that helps

look at this part at www.repairclinic.com/SSPartDetail.aspx?=t-LSR5132PQ-%3d%3di541811&PartID=541811 This is a washer's lint catcher and when clogged will prevent complete water removal. As far as the unbalanced check the levelness of your machine in both directions.

hi there,

Most noises from a washing machine occur during the spin cycle. If you hear loud thumping/or sound
during the spin, the load of clothes may have become unbalanced. Stop the washer and
redistribute the clothes, then re-start it. Repeat these steps if necessary.

If your Kenmore is agitating and spinning at the same time then you have a gearcase problem. The gearcase is warranteed for 5 years part only. The labor would run around 133.00 Your model is a direct drive washer and changing out the gearcase is not that bad of a job. Part number for the gearcase is 3360630. Catriver..post back.