Where can I get a scematic for the main circuit board in a Vector Power on Board jump starter

UpBright AC Adapter Charger For Vector 450 Amp Jump Start System...

This is a generic charger cord listed by Amazon specifically for the Vector 450 Jump Starter.

I just checked eBay they have a bunch if them from $ 8 and up..check it out good luck..

I NEED A POWER SUPPLY AC ADAPTER FOR VECO12POB BATTERY JUMP START SYSTEM.

Where can i buy the power cord to recharge my Power on Board 12 volt 450 amp

12 v Dc @ 1 amp...Radio Shack

I have the same problem: today I tried a 12 volt, 1500 milliamp (1.5 amp) power cord and it has charged mine halfway, so far. It fits the plug in, but not certain, yet, that it has enough power to fully charge.

Tengo varios cargadores no se cual es el de vector necesito saber cual el la salida y cuando tiene de entrada

Radio Shack

What your seeing there is indicating fully charged.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

If you have burnt the transistors that are located on the circuit board, then you wont be able to repair it I dont think because in the circuit board there are probibly mulitple layers of electrical wires the are extremely small and fine that would make it impossible to connect the transistor to the right layer. Try contacting the manufacturer though