Question about Kenmore 22422 Top Load Washer

1 Answer

Leaking My kenmore 22422 top load washing machine is leaking I have pulled off panel etc...can not find where water is coming from . I see water standing up on bottom back of machine but for the lifeof me Icant see where its coming from also in front i think its leaking from pump but that might be coming from back...Can you help

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 126 Answers
Re: leaking

Check your water valve at back and your water connection.if there o k it probably is your pump.

Posted on Nov 22, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Water standing under washer...where to start?

Give a model number ,remove outer housing to find leak. 22422 is not a complete model number.

Feb 04, 2011 | Kenmore 22422 Top Load Washer

1 Answer

Washer machine

Sounds like the hot water solenoid is stuck.

Feb 11, 2008 | Kenmore 22422 Top Load Washer

1 Answer

Machine is leaking water from somewhere?

there is a seal between the drum and transmission,more than likely thats where its leaking. also check your fill hoses and valve

Jan 09, 2010 | Kenmore 22422 Top Load Washer

1 Answer

I have a kenmore 90 series top loading washer and every time I wash clothes there is water all over the floor.

Disassemble and look for problems, there are several smaller hoses that can come off and allow leaks.

Sep 13, 2009 | Kenmore 22422 Top Load Washer

1 Answer

I have a Kenmore Elite Top Load 5 years old which leaks ONLY during the spin cycles. I beleive it may be water coming over the top of the tub. I need to comfirm and get instructions on the removing of the...

it is the water pump probably it only pumps out and has pressure on it when it is spinning easy to remove just pull it away from the wall a couple of feet and tilt it back lay down on the floor and it is the first thing you see next to the front panel two clips and a couple of hose clamps

Jul 01, 2009 | Kenmore 22422 Top Load Washer

1 Answer

Kenmore series 70 tip loader washer is leaking

your just seeing the water that is leaking dureing the wash cycle unplug washer there will be 2 screws on the header panel 1 on each side take them outgently pull header panel to you then flipupunplug wiring harness thas to the cabnet there will be 2 clips 1 on each sideuse a flat screwdrive and pry back they will come out tip cabnet back to you the whole thig will come off look at the pump in the front it has a weep hole in it see if it has been leaking from there

Jun 27, 2009 | Kenmore 22422 Top Load Washer

1 Answer

Kenmore 80 series. Leaking from front under washer. Can hear standing water under agitator/basin

Usually with this situation its a pump leaking, does it leak mostly during use.if you lean appliance back, should be able to take a peak underneath at pump. will just need to be replaced if leaking.

Jun 08, 2009 | Kenmore 22422 Top Load Washer

1 Answer

Kenmore 22422 seeping water from under machine

look underneath the washer.there sould be a hose there.sometimes an unbalanced load can cause the hose to rub up against sharp metal when the machine vibrates.mine had a zip tie that held the hose to close to the edge of the machine which had some sharp metal and it put a small hole in the hose.hope this helps.

Dec 19, 2008 | Kenmore 22422 Top Load Washer

1 Answer

Kenmore 22422 washing machine leaking

Your going to have to take the cabinet off to get a better look at where its coming from. I can walk you thorugh it if you want. Your best to enter a live chaf for this. Thanks Dave

Dec 18, 2008 | Kenmore 22422 Top Load Washer

1 Answer

Water is coming out of the bottom of the washing machine

Tip the machine back and remove the 2 clips holding on the drain pump. Remove the hoses. Then turn the pump over to where the motor shaft enters it. There will be signs of water leaking out of the pump. Your local parts store will have the pump instock.

Nov 22, 2008 | Kenmore 22422 Top Load Washer

Not finding what you are looking for?
Kenmore 22422 Top Load Washer Logo

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Jesus  Colon
Jesus Colon

Level 1 Expert

12 Answers

Fred Sops

Level 2 Expert

271 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides