Question about Optoma EP719 XGA DLP PROJECTOR 2000L 2500:1 CONT DVI-D WITH HDCP Multimedia Projector

Open Question

Orange light stays on when trying to power up optoma ep732H

When my optoma ep732H projector is in standby mode, green light flashing, I push this button to power on and the green light goes to steady, but after about 20 seconds an orange light comes on next to the lamp icon and stays on for about 2 minutes then the unit goes into standby mode. The directions only say to contact service center for this problem..can anyone help?

Posted by on

1 Suggested Answer

  • 14 Answers

SOURCE: orange light on lamp icon on Optoma EP732H Projector

This same thing happened to me, I removed the bulb and put it back in, it reset something and I was able to use the projector again.

Posted on Jan 16, 2010

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


1 Points

Related Questions:

1 Answer

Optoma Theme scene HD81 will not power up. The on / stanby light on the box just keeps flashing and appears not to send any power to the projector.

Probably the separate box is a learning remote. Have you tried to turn on the projector at the projector?

Dec 05, 2012 | Multimedia Projectors

1 Answer

Optoma ep 1690, the on/standby led is flashing green but when I try to turn it on the temp and lamp led's flash twice and nothing happens, the on/standby continues to flash green.

The projector lamp life may have exceeded its safe limit, check your instruction manual, sometimes you have to hold the on or off button for 10 seconds to reset this. All manufacturers are different but that may be the problem.

Here is a copy of the manual, I havn't read it, my solution is from experience of other projectors.

Good luck

Aug 04, 2011 | Optoma EP1690 DLP Projector

1 Answer

Optoma Projector power LED is blinking green,funs are not working, lamp not function, how can i solve this problem

i'd say power supply issue, but the led is blinking green. this means that it thinks it's in warmup/standby mode. but if nothing's running, the main board might be bad and needs to be replaced.

Dec 02, 2009 | Optoma HD65 DLP Projector

1 Answer

What does it mean when that blinking green light turns to orange one in lp 350?

This would be "Standby"
When you press standby, the display and audio turn off and a blank screen is displayed for 15 minutes.
You can change the amount of time the projector stays in standby mode; see “Standby Time” on page 27 for details.
The LED lights orange while the projector is in standby.
• If you press standby again within 15 minutes, the projector returns to normal operations immediately. The LED changes from orange to green.
• If you press standby again after 15 minutes, there is about a 60 second delay before the lamp turns back on. The LED flashes green while the lamp is re-lighting.
• If you don’t press standby again, the lamp turns off after 15 minutes. The LED lights orange while the projector is in standby.
The full manual can be found here:
Infocus customer support
Infocus LP350 Manual
I hope these help

Sep 18, 2009 | InFocus LP350 Multimedia Projector

2 Answers

Powers on but no lamp light

Did you find a solution to this problem? I have the same thing with my Optima 1690...

Jul 09, 2009 | Optoma EP750 Multimedia Projector

2 Answers

Optoma EP755 new lamp when power standby button

you need to reset the lamp timer, usually done by holding some buttons while turning on

Mar 10, 2009 | Optoma EP750 Multimedia Projector

1 Answer

Optoma 719, can't get lamp and fan to turn on.

There is a stuffed 10v 3300uf capacitor on the power board. You need to replace it.
Bellow you can check in the picture where the capacitor is located.
Notice that in this picture I have already took the bad capacitor out and replaced with two small cords to reach the bottom and test the new capacitor.
To reach this place is not fast, several layers of plastic and metal must be removed, but is not a hard task to take the capacitor out and replace it for another.
It works just great! Now it is back on track with awesome image.

Jan 31, 2009 | Optoma EP719 XGA DLP PROJECTOR 2000L...

1 Answer

I am trying to replace a bulb on a optoma ep732h. I have the fixture out but am not sure about the bulb proces.

The fixture and bulb are designed as one piece. When you order a new bulb it comes with the black fixture.

Dec 09, 2008 | Optoma EP732H EZPRO DIGITAL PROJECTOR...

2 Answers

Optoma EP 732H Blue/purple tinge

Hi jmm521

Try using a different VGA cable as connection - WILL solve your problem !

Thanks for using Fixya !

Apr 29, 2008 | Optoma EP732H EZPRO DIGITAL PROJECTOR...

1 Answer

Orange light on lamp icon on Optoma EP732H Projector

This same thing happened to me, I removed the bulb and put it back in, it reset something and I was able to use the projector again.

Nov 12, 2007 | Optoma EP732H EZPRO DIGITAL PROJECTOR...

Not finding what you are looking for?
Multimedia Projectors Logo

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Optoma Multimedia Projectors Experts


Level 3 Expert

2236 Answers

color wheel light...
color wheel light...

Level 2 Expert

137 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

5327 Answers

Are you an Optoma Multimedia Projector Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides