There is a vibration noise on my Samsung #RF217ABBP. The vibration is loudest on back midway up. Anyone know what causes this vibration and is there a fix?

Dry bearing and a slipping belt is the most likely reasons. A belt slipping causes vibration and squealing.

it could be center bearing, if its going bad it can also cause a vibration, make sure you have sufficient fluid in the diff as well, you can also get a noise and vibration from collapsed motor or trans mounts

same as the last post...If the refrigerator wont stay on the start relay may be defective. This may have been caused by the leaking door that overloaded the system. The relay is a small box mounted to the side of the compressor and provides power to the compressor start winding for a split second at start-up to help get the compressor get started. If its defective the compressor may run off and on (a lot) or not at all and the refrigerator will not get cold enough. Fairly easy to do and reasonable

I suspect that you do not have a problem. . The standard operating temperature of a freezer is around -20 degrees CENTIGRADE (-2 Farenheit)

Your freezer has an option to display degrees C and degrees F, I suspect it is showing farenheit

I have taken a look at a copy of the manual, which can be found at:

http://www.manualowl.com/m/Samsung/RF217ABBP/Manual/142915

But for the life of me, I can't see how to change the display from C to F and back anywhere in the guide. If I am right, swapping the display back to Farenheit will solve the display issue.

If you are unable to change the display, you can try calling Samsung in arlington NJ on 1-800-726-7864.

Hope this helps. Please add a comment to this thread to let me know if the problem is solved or if you need more help

Noise in pipe means vibration.
Pipes vibrate when water turns corner, or if there is a clog somewhere in the line, or if there is air in the line.
Water heaters make noise when sediment builds up inside of tank.
I would probably try to track location of noise, and then put that spot on top of suspect list. For example if sink has shut-off, and noise seems loudest there.

Interference fit- meaning it can be worked off with a little help of a hammer andpunch, It can also be a slip fit so try before you pry. Good Luck _Ned_

Hey I dont know if my solution will work on the lg dare but it worked on my phone. I just hit the back cover twice while it was on and it vibrated

MINE DID THIS TURNED OUT IT WAS SOMETHING INSIDE THE HEADPHONE JACK. AFTER I PLUGGED AND UNPLUGGED MY DAUGHTERS HEADPHONES A FEW TIMES MY PHONE STARTED WORKING AGAIN PERFECTLY

What Make & model is your TV set ?

Need to know the model number to help you.