Looking for a lid for a centrex washing machine model ctw60518

yes go to the manufactures website and request the spares department for the part from them eric

Hi just read your posting.Are you in Australia?If you are I can help you.Please reply with additional information and I am sure I can help you.Pump could also be jammed or blocked.Did you remove the pump and check for objects?Looking forward to your reply.

Look for a broken lid switchAll the models over the years have changed the way you get into the machines but the basic concept is the same. The cabinet is removed to access and service this washer

Drain and spin is in the same direction on these washers.
It won't spin with lid open. Newer models won't spin or wash either with the lid open.
Basically the lid switch has a green ground wire and 2 hot wires.
Jump them 2 hot wires as shown here at the quick connect to look for leaks and noises AND to see if the lid switch has failed.

Manual and more HERE



If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi just read your posting.Now I know you supplied the model number in your posting but could you please supply the name of the machine which should be written on the control panel.Is it an ENDURO or an ESPRIT --etc--?Please reply with additional information and I can help you rectify this problem.Looking forward to your reply.

Sorry, but as far as I know, there are no parts available for Centrex appliances. Centrex are cheap Target brand machines, and if they fail under warranty, they replace the machine. Out of warranty, you're out of luck. I'm a tech in NSW, and have not been able to source any parts here at all. One thing you could consider is calling the Fair Trading Office, as it is reasonable to assume you will be able to get parts for a washing machine less than 10 years old- they may be able to advise you further. Also, try going to the retailer you purchased machine from, and ask if they have a supplier of spare parts. Good luck!! PS. you could also try taking hose into your local appliance repair shop, and see if they have a hose off something else that might fit- a lot of hoses are similar.

Is the machine new or old? How long has this been a problem? Has this been occuring slowly or has it started suddenly? Before you give blame to the machine, I suggest you wash your clothes at a laundromat or a friend/relative washing machine to see the results you get. Also, the detergent could be partially at fault especially if you use too little or too much (too much will cause a film to build-up on the clothes that cannot be washed away enough durung rinse). IF AFTER TRYING THESE SUGGESTIONS YOU STILL HAVE THE PROBLEM, open the lid while your Maytag is washing to see if the water level is sufficient and to see if the aggitator is moving; note- you may have to open quickly and check very fast to see if there is aggitation movement because some models stop the washing if you open lid (all models stop the rinse/spin action if you open lid.Goodluck, Macgivor

The part that the screw holds is turning independently of the screw. Remove it and inspect for torn splines or other motion locking device. Repair or replace the part using Loctite on the screw threads.

Click on the link below


http://www.stareast.com.au/

problem with lid switch

my kenmore washer will fill up but it will not agitate.