Dreamland electric double blanket suddenly stopped working after making bed in the morning.

Dual controls implies that the blanket has two separate heating circuits. Do you experience the same problem on each side? If not, you may have a faulty thermostat. If so, it may be a faulty controller or power supply issue.

I\'m having the same problem as Jenn. Tried unplugging it and left it for a day. Both sides are now not working. How can I get it to work again? Husband is having a hissy. Please just tell me what to do. or tell me how to download the manual. Haven\'t had this for very long 2 months. if any help.Mary Ellen I did love this when it did work.

http://home.btconnect.com/ledaproducts/page10.html had the same problem myself, looks like its knackered

I have been getting over this problem by operating the switch slider very rapidly. Sometimes it has to be done back and forwards a dozen times before the light stops flashing.

In a standard 3-way switch arrangement you can turn the light on or off from each position.  If the wall switch has failed then only the bed switch will turn the light on/off.  Replace the wall switch with a new 3-way switch.

"FF" or a blinking light will display meaning “Fault Found”. The “fault” is in the amount of power available to the blanket, mattress pad or throw.
There are several causes to this problem:
1. Bedding product is plugged into an extension cord, surge protector, power strip, or not plugged into a direct wall outlet.
2. Bedding product wasn't plugged in properly.

To FIX this problem, do the following to reset your bedding product:
1. Unplug the power cord from the electrical connection.
2. Unplug the cord from the actual bedding product itself.
3. Re-plug the cord into the bedding product. Make sure the connection is secure and complete.
4. Re-insert power cord back into a wall outlet.

If the 4 steps above are not followed in order, the bedding product will not properly reset.

Same problem, but now it is ok.  I emailed Sunbeam and was told that if my blanket was not plugged directly into a wall outlet it was not getting enough power and I needed to plug it into a wall outlet taking these steps:
1) Unplug from the surge protector/extension cord 2) Unplug from the blanket 3) Plug back into the blanket 4) Plug into a wall outlet