I need a code for my Hitachi 50HYT62U tv for virgin tivo remote

Your LED backlights are bad, but Hitcahi parts can be hard to get sometimes

Main digital board fault. Check and replace it. Contact any service technician. If you wish to get more details visit the site linked here. http://electronicshelponline.blogspot.com/

Virgin Media Remote Control Codes

www.virginmedia.com/.../vplus-remote-control-codes.php

Virgin MediaYou can set-up your Virgin Remote Control to operate the Volume and Mute functions on your TV so you only need one remote to watch TV. Firstly, please select ...Missing: vm202 ‎alcatel

Customise your TiVo remote to control your TV - Virgin Media

www.virginmedia.com/tivoremotesetup/

Virgin MediaTo clear your changes and reset your remote to its original settings: Press and hold down and on the remote at the same time until the light on the top of the remote flashes green twice. Press three times, then press. The LED will flash green four times and exit programming mode.Missing: vm202 ‎alcatel

Virgin Media VM202 review by 3G.co.uk

0291,0299. Check these codes. If you wish to get more details; check the sites linked here. It has set-up code list & set-up procedure to many popular brand remote controls. Common set-up codes to check with TVs and other devices are given, in the order of the "device's brand name" in alphabetical order. Pull up older posts. Surf the site with patience. Surf the sites by type in the brand name to your set, in its search box.
http://electronicshelponline.blogspot.com/
http://remotesearch.blogspot.com/
http://electro-medical.blogspot.com/
http://electrohelponline.blogspot.com/

You need to connect the cable signal into the TiVo, activate the TiVo with Virgin Media and then you can record using the record button on your TiVo peanut-shaped remote control.

Oh boy. here is the problem. i have also a 106240 IR/UHF receiver/transmitter that changes the channels in the satellite box from another room so i can watch them in a second tv at channel 4. the original remote for the 106240 is broken and i bought another UHF remote #153638. So i need to program the new remote to work and link with the 106240 receiver, NOT the satellite box or the tv. Is there any expert here to enlighten us how can be done ? Very simple question :how to program the remote 153638 to link with the 106240. Thank you in advance

0088 0059 0142 0060 0072 0004 0009 0091 0001 0012 0061 0137 0139 0141 0179 0227

Direct Code Entry

1. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.
2. Press and release the desired Mode button (TV, VCR, etc.). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashes.
4. With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your device, try one of the other codes for your brand

Hello,

Since you haven't mentioned the EXACT model of your remote, I can't exactly tell you the instructions. BUT you may choose your EXACT remote and refer to the instruction / codes from this link:

Virgin Media Remotes

I hope this helped you.

You can rate my answer if you appreciate my help.

Thanks!

-damneddle

Research at www.HitachiServiceUSA.com ..........T.